Dexcom G7 Over Patches - 25-Pack Waterproof & Breathable Dexcom Stelo & G7 Over Patches in 5 Colors Set with Hardshell Cover, Multi-Layer Protection for 10+ Days (Multicolor)

So far I really like these stickers. They do there job well waterproof and the little dexcom g7 cover is nice to have for protection. I highly recommend them.

Stays on fine when it getting close to the time to change it out it lifts up on the end but overall good product need different patterns and colors 🫶🏽

Finally I found a overpatch I love there’s only one thing I would love to suggest to them.. if you look at my Omni pod there they leave a lil tab so it’s super easy to pull the paper off to stick it on! If you could do that these would be perfect! You see I’m older with arthritis and peeling the corners off after you have the middle stuck on is not so easy! But great product!

I love the plastic protective cover. The sticky “bandaid” type cover not so much, but ai haven’t found other suitable options. They lose the adhesive around the edges and roll up which makes them tacky looking. Trying to pull them off and change out half way through a sensor’s life isn’t fun, but overall I still like securing the sensor and protecting it with the plastic cover.

Product is ok I’ve used a whole order of it and I am not satisfied with it. It fringes after about 4 days and it is not as waterproof, if you go swimming or sweat a lot it will come off and will pull the sensor with it. I will say the little cap it comes with has been super beneficial to avoid scraping the glucose sensor off on doors and such, just wish it last the full 10 days I have to keep my sensor on between changes.

I volunteer with a local fire department. In my leisure, I'm usually running around in a t-shirt. When we have a call, I have to put on my Turnout Coat. When the Emergency is over, I take it off. This is where I most often had my CGM pull out.I was using a CGM by another major manufacturer. No matter which brand of Over Patch I tried, including elastic armbands or hook and loop armband, my CGM kept getting knocked off. I got tired of calling the manufacturer and requesting replacements. The "customer service" rep would go through their question tree to make sure that I was doing everything possible to not lose my CGM's, making me feel like a criminal or a scammer.When the opportunity arose, I switched to the G7 and began my Over Patch search all over again. I tried two others before I ordered the Kovoq. The adhesive is relatively strong. The reusable plastic shell is where the magic begins. Even if the Over Patch accidentally gets pulled off, that only takes the plastic shell with it. The CGM should still be attached to your arm.It can be challenging to apply by yourself, but if you have someone to help you, it takes about 30 seconds to get it aligned and applied. I've had to change Over Patches a couple of times because they had gotten frayed and started to pull away but the cost of an Over Patch is way less expensive than replacing a CGM.One thing I do recommend is getting a bottle of Adhesive Remover to remove residual glue when changing Over Patches. The one I got recommended Cotton Balls but I found that a piece of first aid Gauze works much better.

I feel like these are made poorly and Iwould not recommend purchasing them. I applied according to directions and they do not hold up after one time even bathing.

I am tough on my dexcom7s. I run into doorframe, shelves....and knock my sensors off. I tried a protector that fits over the sensor and has a wider base. It improved my results.This one is a solid sticker and has a hard plastic "hat" over the sensor.I have hit it a couple times and did not dislodge the dexcom. So works great!The stickers that come with this sem to work with sweat, water, and very sensitive skin. I break out at most adhesives, this one has been good.It does fray with showers. For me, the point is to have this on for protection from bumps. Also, to provide a sacrificial layer for showers. When it starts to peel, I remove the outer sticker and "hat", replace the sticker and reapply.