Leviton42777-1WB Surface Mount Backbox, Single Gang, White, 1.45"

I used this with generic surface channel and used 14/2 nomex. I did have to cut new inlet and outlets in the box because of the way I mounted the box. Easy to do with a drill bit in a file.

My first time using one of these and it was really easy. The cut outs pop out easily depending on what you need. The holes are predrilled and the box is get plastic. All of it was easy and I would highly recommend this

Works great

i like the flush design

Unlike other reviews I read, the punchouts were easy to remove and did not splinter or crack the box. I like that it has all the standard options available for different conduit and wire channels.

Exactly what I needed, I installed it on an outside wall that was sheetrock on the inside and concrete block on the outside for a perfect installation because it fit in the space flush and still had enough room for the wire to fit inside the box.

Does OK, but the brass nuts inset in the plastic tabs did not have supplied screws. I could not figure out the thread (its not 32), so I had to work around this by using a short screw, cross threaded, with a washer. Got it tight enough. I can see why someone would break the tabs if they tried to use a standard switchbox screw. If you did and tried to tighten it, the plastic tabs would break right off. Guess I could have taken it to a hardware store and found the right thread, but it worked out the way I did it without the trip across town.

Just as described, easy to install, well made, heavy duty!