Lansky Super C Clamp: Knife Sharpening System Mount - LM010

This tool is incredibly effective and of high quality. It’s incredibly easy to use and will securely hold on most workbenches. The blade holder is a bit tight out of the box, but it loosens with the first few uses.

Stabilizes the whole system. Works beautifully.

really helpful and fool proof way to get a really sharp blade.

Good product

I can’t recommend this enough. If you are buying the lanskey sharpener, this clamp is a must have!

The product is works how it’s intended to

If you have the Langley knife sharpener, you need this clamp. It makes it easier to hold the knife down on to a flat surface such as a table. Only downside is that it has a little wobble when you tighten it down so your knife might move a little as your passing the stones through the edge.

About two years ago I put my Lansky system in my closet and hadn't touched it since. I got tired of holding my knife and guide system in one hand and using the rod/stone in the other. I was not getting the results I wanted on my knives. I put some time into learning how to sharpen with a ceramic stone by eye and can say I can get a razor sharp edge with no guide. This took time and lots of practice to be able to keep the knife at the same angle both directions.So the other day I saw this clamp system in my local store and it peeked my interest since I make custom knives and I am constantly sharpening them and my friends knives. I ordered from Amazon and put it to use the first day it arrived. I can say that having the guide system attached to this clamp made all the difference in the world with the Lansky system. Even though I can do it by hand now, I like this for putting my first edge on my hand made knives. Instead of eying it, I can say the edge has been set at a --- angle to whoever I sell the knife too.My first fear was seeing how small the "knob" was where the guide system sits. I thought it might pop off while sharpening. And the thought of my knife falling onto my leg or foot kept running thought my head. So far so good, but I would still like to see a better or more secure way to attach it. I know it is meant to be able to pull off quick and flip the system over to do the other side of the blade, but there has to be something that can secure it and still have the quick disconnect.Other than that, it is a great system if you have or are going to buy a Lansky.