Spike Power SportsSpike Powersports YXZ Fender Flares By Spike Power Sports

Was a bit skeptical as to whether to buy these or not after reading some of the reviews, but some glad I did! After the first run, I was Sold that these were a necessity for any YXZ to prevent the Tires on both the front and rear from chucking mud either in the cab or up onto the rear Rad cooling vents. I ran 600kms in various terrain from Mud to deep Water to Rocky Gravelly roads and hardpack trails and dirt roads and they worked to totally eliminate and or reduce everything off the tires from entering the cab or landing on the Rear Rad Vents! As other have mentioned, they arrive almost totally flat because of shipping, so I used a heat gun and my vice to slowly heat up the plastic and exaggerate the Bend lines it came with, until it matched my machines body lines, attaching the highest screw on the front fender first, making sure I had just the right amount of bend to fit snuggly up into the stock fender. The first fender took me taking my time about 1 hour, then the second front fender was only 20 minutes, now knowing what to do. The rear was literally 10 mins for both, so no worries!I am very happy with them and so is my wife who used to get covered in large globs of mud entering or exiting any sloppy mud holes or puddles we encountered on the trails, as my M1 Evils are nasty Mud Chuckers at times for sure, and now she enjoys our time together in the SxS much more. Worth The Money. Now the YXZ Body Lines Resemble the Stealth Bomber! Hope this helps!

A little fitting adjustment using a heat gun and they fit just fine (they were a little flattened out from shipping)

My windshield is the proof. On muddy trails I only cleaned my slightly spotted windshield 1 time! Wish I had purchased sooner!

poor design, does not fit 2017 yxz 1000 worth a hoot, can do a better job if you cut hard plastic out in a design and zip tied it on. not a great production to follow the body of the yxz without putting a LOT if stress on the bolts, i'm sure a little hard riding and they will come loose , sending them back

Update: Definitely worth the time, effort, and cost. Compared to the outside, very little made it inside.Fit and finish is excellent. It did take a few minutes to fit the front. I ran hot water over the folded areas and held them in the desired shape till cool. Once they were installed I used a heatgun to finalize the fit. Trying to drill from inside out is not an option, so I used an old sheet metal workers trick to transfer where the holes on the extension was located. I attached a piece of paper with the hole locations marked on it then slipped the extension in place with the paper on top of the fender. The rear extensions were a bit challenging because I have a Dragonfire bed extension installed. I didn't give it 5 stars because I found the two sides were no identical. If they were it would have been possible to use one side to template the other side.