EVIL ENERGY 6AN Fuel Line Kit,AN6 Braided Nylon Fuel Hose CPE 10FT Black

Berry high Quality and ease of use, still holds and does great job, just to recomemd

Good Quality hose and fittings. To cut the hose wrap it tight with electrical taped cut it with Hi speed saw or angle grinder with cutting wheel to make easy fitting the hose into the adaptor. use lubricants like petroleum jelly, Silglide, light grease will.

Easy to put together and better than the others I’ve tried. Evil energy has great prices and products to offer.

Great quality. After using high dollar hose and end fit years. These are just as good. Plus a kit with ends and hose it a huge time saver

Nylon casing is a pain to assemble at first, but not bad once you get the hang of it. Decent quality for the price and worked well for assembly of my fuel pressure regulator setup.

Great products will definitely by again

I used the lines and fittings to install on my classic mini. They were by far the easiest AN fittings to install and no leaks.

I had a problem with a squirrel going into my engine bay and biting through the plastic elbow of the OEM fuel line for a Mazda5 minivan. Not sure why the squirrel was attracted to bitting it at the plastic tip, but it did it twice, causing gas leakage. After installing this, the squirrel could not bite through the elbow, but it did attempt to bite through the hose as there was an area of the nylon braided section that was chewed. I might have to get stainless steel braided hose if it tries to keep on chewing through. Cost-wise, this is much cheaper than Mazda OEM fuel line which was around $80. The Mazda required fuel fittings that are 5/16" wide. 3/8" fittings were too large.