ACDelco GM Original Equipment 214-2339 (22783573) Vapor Canister Vent Solenoid

Fit perfect and fixed my check engine light issue. I had a check engine light on for purge valve solenoid and had problems putting gas in my truck. This is the exact part you need for 2011 Chevy Silverado 5.3 crew cab LT. It’s not hard to install if you know how to follow directions and have mild mechanic experience.Tip- The plastic piece needs to come off and is meant to, so you can route the hose to the gas tank.

fit and works as it should . maybe i did not pay too much attention when ordering , and had to order additional cable (pig tail) to accommodate for difference of the solenoid connector shape . my original was oval and this is square

Unfortunately, this did not fix my problem. Autozone scanned my truck, said this part was bad, so I changed it. that did not fix the problem. I had the dealer scan my truck, they said the tank sensor was bad, I changed that sensor and that fixed my problem. This part looked and installed just like OEM, If I needed this part, I would buy it again.

Exactly same factory part for my make and model. Had to do lots of research and ordered to find out if I was same. Part fitments guide on Amazon is not always accurate so you will need to do a little searching to find out forsure. Then order it anyways if it's free returns. If it doesn't fit send it back.

No me agrado porque al mes dejo de funcionar

Make sure of the correct one for your vehicle (went thru 2 others before getting the right one). Check the length of the hoses, and compare the bends in the semi-hard one. You cannot reshape it to fit! Do NOT throw away any of the old parts until you reinstall the new one. Also, it was easier for me to take off the rear left tire of my 2011 Crew Cab Silverado to unsnap the old hose and resnap the new one (open gas cap cover and bend down and look up above gas cap and you will see 2 little plastic clips holding filter in place.

Nothing but OEM quality for my Silverado. I had a check engine light on and I couldn’t fill my gas tank up without it spewing back at me or clicking off. Did a u tube search and then got this ( since the local auto parts store didn’t have it in stock and could t get it for a week) and changed it out. Pretty plug and play and now no check engine light and I can fill my tank up like a normal person. My truck is a 2011 Silverado ext cab regular bed.

This part is exactly what you need if you have a P0449 code/ check engine light and having issues at the gas pump when the nozzle keeps clicking assuming your tank is full and you know it's not. It was taking me 15 minutes to pump $10.00 worth of gas.Somebody always pulls up and is waiting for that same pump. What a pain.Troubles all over now. 100% satisfaction.Spent days looking for this part online and in auto parts stores. Way to expensive.Get it here and inside of 1 hour you are done.Such a pleasure to find watch your looking for / slap it on with the quickness and it works. No need to have someone else reset that code to get the light out. Disconnect your battery for about 30 seconds and that will clear the code / light.Done.Extremely Satisfied Customer $$$$$$$

coincide en la mayoría, el único detalle es que el tubo que tiene el filtro de esponja debería ir cerca de la transmisión pero no pude colocarlo ahí, lo deje en otro lugar por el momento. este esta diseñado para ubicarlo en la parte trasera por donde esta la llanta de refacción.los códigos desaparecieron en 3 días de pruebas, en caso de que me saliera otro código referente al evap ya lo comentare aquí.

"Check engine light' would not go off. Replacing this part fixed the issue