Kinstecks 4PCS Motorcycle Indicators Flowing Turn Signal Lights Motorbike Turning Indicators 12V 12 LEDs Bulbs for Motorcycle Motorbike Scooter Quad Cruiser Off Road-Y Shape

Why did you choose this product over others?:Looked great and when they arrived they were easy to fit. I just had to change to fitments on the end of the wires to suit my connectors. Work brilliant and look eye catching.

top class people to deal with great value for money

Love the aesthetics of them with the sequencial lighting. Had to buy adaptors to make them fit my Yamaha MT-07 but that was to be expected. They did seem to get a little brittle over time where the indicator meets the thread. I bought a second pair recently and the quality seems to be much better. Would highly recommend! Remember you may need to change to a led relay if they start flashing fast!

Worked well, easy to install. Look good, too. Bright, waterproof as expected.

I don't often leave bad reviews for products on Amazon because I think that if you pay peanuts, then you'll get a poor product but the reviews for these seemed to be mostly positive so I gave them a go.I received four in the box but I only wanted two. One stopped flashing after a week or so; I used one of the remaining two as a replacement. Both worked fine (you'll need to replace your relay if your bike doesn't have LED indicators as standard otherwise they will quick flash).However, they both came loose from the nut section and were then hanging down from my tail tidy but the wire, flailing wildy in the wind while I rode my bike, completely unaware no one could see my turn signals.The rubber design means that even a gentle knock can dislodge the indicator body off a small flange which seats inside the rubber and then you have to re seat these wherever you have fitted them. Even the sheathing only runs half the length of the wire so if it's longer than 6 inches, externally, water can and will penetrate the unit. It's such a poor design and, in my opinion, really not fit for purpose.I've attached a picture for reference. I ended up sending these back and buying the Oxford ones (twice as costly) but much better quality. My advice: spend a little extra and avoid these.

Happy with these on my zx6 P8F. Had to get the led relay to go with and brackets so they would attach to my tail tidy. All in £26 took half hour to fit them. Just cut my original indicators off. Had green and black and yellow wires. I through crimped green to red on the new led ones and black/yellow to black. Insulation taped and fabric taped the joint tucked away behind plate. Hopefully they last.Picture of the adapters I used. Had to drill them out with a 11mm drill bit, and showing original indicator the other one had snapped off hence the purchase.

Not the best quality and available elsewhere at half the price, however i needed them next day.I had these already one broke, however this set had very short wires compared to the last set and only just managed to reach the bike loom.To anyone buying them, I also wrapped a cable tie around the end where the bolt goes to help keep it in the main rubber. Added a drop of glue to the lowest thread too otherwise as you tighten them the thread just pulls pulls out of the rubber

I've had these indicators installed on my 1998 ZX6R for over a year now, come rain or shine and I've had zero issues with them. Still work the same as the day I installed them. Great product!