FLYMEI Motor Engine Cover, Full Outboard Engine Cover, Water Resistant Boat Motor Cover (Fits 6-15 HP)

Got this for my Mercury 225, fits great and completely covers outboard from top to bottom. Easy to put on and take off and seems to be well built and durable.

Installed this on my 20HP Tohatsu, Did the measurements as suggested before ordering, got the 15-20hp as recommended and it is a perfect fit. Easy to install and really excellent coverage. Very impressed, I'm going to buy another for my 50HP Merc.

I purchased the 60-100HP cover. My engine is 75 and this cover didn’t fit at all. Have to force it on and it’s way too tight on the engine. Other than that no problems with it.

I have 2014 BassTracker boat with a 60 hp 4 stroke outboard. I wanted a cover to protect from sun when stored in my open ends RV shed.Cover was easy to install & a little large for this size of motor ( which is ok for my intended use).It has an inside foil liner that should protect from UV rays. I’ve had wheel covers with same material that is used on motor cover external. I suspect it will discolor (fade) with time. I’ve had for less than a month so I’ve experienced no fading issues at this time.I remove before traveling so cannot speak to its ability to withstand highway speed & wind. Because of oversize, it would not surprise me if it didn’t hold up however for my I intended use it works well and is very cost effective.

Easy on and off!! Compact little package for 20hp. Fits over tiller handle in upright mode.

Measuring is important. Our 2022/23 yamaha 150 is 97" cir. So I purchased the largest cover to fit that part. Of course it is too long which isn't a problem. I could leave it but plan to sew to get it off the ground. It's average for thickness but since we keep boat under a canopy, it will do just fine.

I have a 2021 50 hp Mercury 4 stroke so I picked the 30 to 60 hp will not zip up. I just glanced at your add when I ordered it and didn’t see you recommended measuring. My fault but if you didn’t advertise it would fit the Hp everyone would measure. So a 60-100 Hp cover would fit mine I guess. Buyers beware.

I was pleased to find out that this engine cover actually covers the whole engine including the lower unit, prop and skag. The section of it that covers the lower unit zips up and then above that is a pull string that can be cinched and tied.For the price this is a really nice cover and with the Iowa cold winters any extra protection of my engine is a good thing.As a boater and avid angler for almost 40 years I recomend this product. I have not tailored with the cover on so I cannot attest to it's enduring quality to high speed winds from highway travel or gravel roads if you have to put your rig through that.

Fits extremely well on older 30hp two stroke mercury and new 2023, 25hp four stroke. So easy to install.

La calidad de material y acabado

Fits my 150 mercury pro xs perfectly

It’s a good size. Fits my 150

Adaptation parfaite pour mon 50 forces