be quiet! Pure Base 500DX ATX Midi Tower PC case | ARGB | 3 Pre-Installed Pure Wings 2 Fans | Tempered Glass Window | White | BGW38

I did grab this while it was on sale for $57, so it was a great deal for me. I'd definitely recommend at the sale price, and at the current price of $94, I'd say this is good case for what your money will buy - depends on what you are looking for. This does well with having dust filters (huge plus for me since I don't like cases without them), clean look, some RGB, glass side, quiet fans. Look at the pros/cons list below and make that decision. I'd compare to other cases in this price point and go from there.PROS:- Removable dust filters where you need them- Good airflow- Plenty of space in the back for cable management - compared to some other cheap cases- Has RGB lighting in the front and the top (inner side of case) that you can change with a press of a button- Good build quality with temp glass side panel- Comes with 3 decent fans that are quiet and move decent amount of air (140mm fans)- lots of SSD mounting spots- lots of removable panels to help with cable management or installationCONS:Honestly, for the price I got it at, there isn't a con for me.If I must nit pick:- the front panel needs to pop out for you to access the dust filter. Not too convenient compared to some higher end cases. At the current price of $98 (BGW38), I would expect a better design.- (pictured) The removable panel is a bit tight for the motherboard cable. It has to go in at an angle due to the design of the folded metal (shown by the arrow).

Let me start off by saying that this case is super nice and its namesake holds up. It is quiet and I am very impressed even though I have very limited experience building a pc in general. But this is a great starting point case for amateur or experienced builders.The quality of the case is very high and sets the bar pretty high for other cases in the price range to live up to. Everything I installed went in with ease except my ability to manage all the power supply cables once everything was connected but I managed to fit everything. If you are not installing a HDD in the tray then you could just remove it and have more room to stuff cables in. Thats the only thing I really struggled with because I used green cable extensions. I'm not going to knock the rating of the case for that though.My components had no trouble fitting in this case. I didn't even have to move any standoffs for my B550 motherboard. There are plenty of wire routing cutouts at the top and bottom. Also plenty of tie down spots on the back for cable management.The thumb screws for the case were thought out nicely. A very nice feature is the power supply faceplate can be removed and attached to power supply for easy installation through the back. Attach it to power supply with screws the slide in through the back then tighten the thumbs screws to the case. Simple and easy.There are 3 stock 140mm fans in the case and are very good fans if you don't want RGB. I chose to go the RGB route and purchased 6 RGB 120mm fans instead. You can fit a 240mm AIO at the top or front of case and a 360mm AIO only on the front of case. I chose a 360mm front installation.Speaking of RGB, the stock double line strip on the front and the strip at the top inside of case are very nice. You can choose a lot of different colors and RGB modes by pressing the button at the front top of case. Or if you hold down the button, it will hand over the RGB to the motherboard software if you everything to sync up. Also, if you choose an RGB power supply, you can see it through the shroud at the bottom of case (see picture). I was concerned at first that I would not be able to see my RGB fans through the mesh front but was elated to see that my worries were for not once turned on (see picture).I have acrylic RGB covers for my SATA hard drives which you can see to right of motherboard. The location is nice to show off the hard drives if you want. But there are options to not.There is also 3 removeable dust filters included. 1 magnetic at the top. 1 kinda hinged on the front. 1 at the bottom that slides out for easy cleaning.The glow that reflects off the case is beautiful ambience...very satisfied once light are off.In summary..I know I rambled a lot but this case deserves it. Great case and well thought out for anyone looking to buy a starter mid case. I absolutely have no regrets buying this. Thanks for reading and enjoy if you purchase!!!

Ok first of all i'v heard alot of good things about be quite! but dang this case is amazing. It has so many places to route cables, the build quality is amazing for the price. Comes with a glass side panel which is held in by thumb screws which is kind of a bummer but that's not even a complaint. It just takes a little more effort to get into when you need to and if you're like me and don't plan on really upgrading anything anytime soon I don't really see it as a downside. The case has GREAT airflow and man is this thing silent. It comes with 3 pre-installed budget be quite fans which is sick, they are also fairly quite so I don't think that's a downside plus I picked up 2 extra fans of the same type to all and all tie this thing together. The case comes with some sound dampening foam on the back panel. has a lot of dust filters including on the bottom and top which are removable for cleaning. The front panel has 2 awesome strips down the front which look amazing, the leds are fairly bright so if you don't like that then I guess that might be a downside but if you are buying a case with led's why would you not want to use the led's... anyways the case also comes with an led light strip pre-installed on the top of the case on the inside toward the front. It's already pre-hooked up to the front led panel's so when you change the lights via the botton on the case it all changes together. if you have a 3pin rgb header on your motherboard you can also hook up the lights to that and control them via whatever software your motherboard uses for lights. all and all an amazing case and is so much better then the last case I purchased. hope this review helped someone!

For the price, this is a great mid tower case. It comes with 3 included 140mm fans (non PWM) which are actually decent for stock fans. Also included is a preinstalled RGB strip on the inside (on the top near the glass side panel) of the case which you can control either with the front panel RGB button or through software. All intakes are filtered, options for mounting a multitude of SSDs/HDDs, plenty of room for cable management under both the PSU shroud and between the back side panel and you have the option to run ALL 140mm fans, which is great.The aesthetics are top notch as well. It has a very clean and simple design and the implementation of the included RGB is tasteful, unlike many cases. It was a pleasure to build in and has great features for this price point, highly recommend!