MEASUREMANDiaphragm Type Capsule Low Pressure Gauge, 2-1/2" Dial, 1/4" NPT Lower Mount, Adjustable, 0-5Psi

Exactly what I needed to monitor natural gas pressure. The dial is simple and easy to read. I have two of these and am very satisfied. My only concern was potential future yellowing of the plastic face due to Florida sunshine. I placed a small canvas bag over the dial that I can instantly remove whenever I need a reading, just to be sure.

Bought this specific gauge because it was the low pressure range (0-3 or 0-5 psi) I needed and there aren't many quality affordable options. However, this gauge was exceptionally well packaged, looks nice, is easy to read, and seems to be accurate. Very pleased with the purchase.

Currently in the process of adding a furnace and central air to my garage mahal. I ran about 60' of 1" polyethylene pipe 18" deep and wanted a solid pressure test before I began the backfill.I had a cheap gauge on the stub up to garage and a more expensive, liquid filled one I purchased at Amazon at the stub up exiting the house.Long story short, 48 hours later the newer gauge was reading 8 psi while the cheaper gauge was reading 10. Rather than moving forward and having to unearth an 18" buried line in the future, I decided to get this gauge.I installed it on a tee after a shut off in the basement to check the whole new run of pipe. I pumped the line up to 10 psi and it's still holding strong. I then took the other gauge and setup a test rig and pumped it up and submerged under water to find a very small amount of bubbles coming from where the brass fitting meets the gauge housing.I also did a pressure test on this gauge and it held 10psi for 2 days before I decided to trust it. It's a little more money than the rest, but a diaphragm gauge is worth the extra coin.

Gauge build seems pretty solid. Bought to test gas pressure on natural gas/propane generators. Have yet to use it. Wish it came with a case but I ended up putting it in a pelican case with my other gauges anyway.

It shows my 1/4 psi just fine

It's exactly what I needed.

My use case was to monitor reciprocating air pump pressure to the aerobic septic system. Was debating between the 0 to 5 psi or the 0 to 3......should have gone with the latter as pressure is only indicated as .6 psi. The supply pipe is a bit large at 1.25 inches ID thus the lower pressure but works fine as the aeration is very active.

Works great

This 5 PSI gauge works very well and is accurate.

Nice high quality gauge, just what I was looking for.

As described

Reçu avant la date prévus. Fonctionne très bien rien a dire

Arrived quickly, was very well packaged and worked perfectly. Great low pressure gauge.