3D Printer Borosilicate Glass Build Plate 220mm x 220mm x 3mm Glass Bed for MK2/MK2A,Wanhao Duplicator i3, Anet A8, Anet A6, MP Maker Select Reprap (220x220x3mm)

It's the exact size for my Anet A2, no trouble with this except I still need to use tape on it to have adhesion but at least it's square and no imperfection. I will certainly order an other when my new bigger printer will come and i will use this vendor.

Well shipped. Flat by .05mm. 9 point z offset. 99.9% flat. Better than my warped bed. Transfers heat well, and a layer of painters tape still holds better than raw glass.

As far as functionality goes, it does the job. The surface is adheres enough that I would not be concerned with any lifting. After printing it is extremely easy to remove. Much easier that the bed which came with the Ender 3. The reason for the 2 stars is the shape. It is square but with the corners cut just over a cm from where the corner should have been. This was not shown in the pictures. All the beds shown were full squares. This caused an issue for my printer when the nozzle primes on the very edge of the bed almost the full length. It basically runs out of bed at the corners and primes in the air.

I bought this thinking that it would be a smoother more durable glass bed for my printer then the 8X10 picture glass I got from the hardware store for 6 Dollars, I was wrong. The surface was not completely flat and within a month of use the bed shattered, not from me removing a print, from the print cooling. I thought that maybe this was a fluke so I ordered another and it also was not as flat as I would have liked. This one shattered when it slipped and fell about 3 feet onto the floor. Granted the last one was my fault it seems to me that a thick piece of borosilicate glass should survive a fall that my picture frame glass had survived before. Unless some improvement is made to this I would recommend going to the local hardware store and buying a stack of picture glass, you can get probably four for the cost of one of these.Experience: 2+ years printing.

Excellent!

glass is clean,packing is very good.

The inductive auto-leveling sensor that is included in some A8 kits is not sensitive enough to detect the metal print bed though the 3 mm of glass. Some sensors Amazon sells are marked 8 mm. These are more sensitive and just barely work, but need to be positioned within 1 mm of the glass.

This is a good quality glass without a question. but you have to be careful if you have a inductive leveling sensor, because this glass is too thick for my 3D printer z axis sensor. After installing this, the hot end crush on to the bed very often, because the glass is too thick

I was extremely nervous about getting glass shipped to me, but Amazon came through again with their awesome packaging - this glass sheet is in perfect shape and is everything I had hoped for .

it is supposed to be tempered glass it is not ,regular galss ( i had to cut the corners to fit my wanhao i3very disappointed

Product description doesn’t match what was received. It’s the wrong size!