Burris Optics Rimfire and Airgun Rings, Durable with Strong Gripping Power

These Burris 1 inch scope rings for dovetail grooved receivers are of great quality! The HIGH rings set my 6-18x44mm scope at perfect height. Bottom of the objective lens is 1/4" from top of barrel. Awesome.

These steel rings are super easy to install and incredibly strong. They do the job and look great doing it. Very slim profile, glossy black, makes a nice contrast with the matte black of the scope. Not a single thing to complain about.

Seems to be good checked them out but did not mount them yet.Burris makes a good product.

They are not the quality that the old Redfield rings were, but they do the job. Wish that gloss finish would have been offered.

Most of the scope rings made for 22 receiver dovetails are lousy. These Burris rings are made to the same standard as their rings for high powered rifles. Definitely worth paying the extra price for the much improved quality.

I mounted a Burris Full view scope to my .22lr. They fit well and I was able to mount the scope trouble free.

This will NOT fit 9mm US dovetail, also known as 3/8"This is an 11mm European Dovetail groove only! Will not go narrower than 10mm.Description and Q&A are inaccurate!And IT IS NOT MADE ACCURATELY!I have included description of the two standards and images of measurements of both a 3/8 dovetail and the Inside Diameter of these rings mount.Again:Get it together and have more accurate descriptions.Let me try to clear this up.3/8” is a type of dovetail mount that is very common.3/8” = 9.525 mmThis Burris scope mount fully tightened is approx 10.6mmThat is larger than the dovetail groove of 9.5 mm.It WILL NOT FIT 9mm dovetail or 3/8”.There are two main dovetail standards:European Standard = 11mmUS Standard = 3/8” = 9.525 mmThese scope rings are dovetail 11mm standards.They will fit 11mm grooves, but NOT 9mm groves.Look at the digital caliper measurement in mm.This one clamps down to about 10.73mm.If the angle of the mount clamp is well made, it can achieve appox 9.3-9.5mm at smallest point.This one stops at 10.73....only slightly smaller than 11mm.It will hold, but it is using a larger angle to clamp mostly on the top of the mount groove....not fit along the entire groove angle. POOR DESIGN for an expensive product from a quality brand.For US dovetail 3/8" look for something smaller than 10mm. And optimally close to 9.5mm. This way you are not at the end of the range for the groove inside measurement.In other words....this will work on some 11mm European mounts, but could be made better. It will not work on 9mm mounts in other words 3/8" in most cases. And if it does....it will not have a good contact.Hope it helps.

Good rings