IQShield Full Body Skin Compatible with Apple iPhone 6 Plus (iPhone 6s Plus 5.5 inch) + LiQuidSkin Clear (Full Coverage) Screen Protector HD and Anti-Bubble TPU Film

Installing the front panel was straightforward. The back panel is a completely different story. The challenge is around getting the little flaps that protect the sides to stick. They aren't sticky in the traditional sense of tape so when you touch them its misleading. I kept trying to get the film wet to make it sticky and it just made it worse.You would think its not going to stick and it doesn't until you put pressure on them against the phone for 2 or 3 minutes.I have a gel keyboard wrist pad and ended up putting each side of the phone on the pad and holding it with some pressure for a few minutes on each side. I needed to wait for the film to dry out so it would stick to the phone. Even then, the adhesion between the phone and film was finicky. But after I got it all to stick and just let the adhesive set for about 30 minutes I noticed it was really sticking on to the phone with very little play. A couple of hours later it had completely fused. Going just over a month now, the film is still sticking to the phone well.

Not designed for the back of the 6+... The sides will not stick at all. The front is off a tiny bit to the right so be very careful! Use camera and home button as the edge maximums. How I made the back work was I applied the majority of the back ans squeezed out the excess air and liquid...after I let it sit for a while I trimmed the sides with quality very sharp scissors. Utilty blades will pull on material before it cuts it. I made sure I did not even touch my 128g 6+... Too much $$$ to mess with. The toughness IS there on this material that's for sure. And for $7 and arriving in 2 days (ordered Friday received Monday!) worth the trouble. 3 stars because I made it work and it's pretty thick plus tempered glass is $45 at an At&t store.

So far so good. I've gotten good at putting these particular types of screen protectors on. This one is nice and clear. The only drawback is the fingerprints are pretty annoying. It is impossible to keep all the prints off of the screen, I'm constantly wiping it down but it's useless to do so.

Works just as described. Took awhile to finally adhere to the sides of my iPhone 6 plus but when it finally stuck it looked great. Had to keep working with it. A couple of tiny bubbles still there after 2 weeks but barely noticeable.

The back part is so hard to install. After I finally installed it, eventually, after about a week, it started to come off from the bottom. it looks very nice though. I would probably get it again if I needed a skin. And for those who prefer a grippy kind of skin, like the original invisible shield, this is not like that. This is not as grippy as I want it to be. Lastly, it's super thin that I can still use my Apple silicone case.

A good product, sticks very well to the back flat portion of the phone. Just not happy with the parts being applied on the sides. They just don't stick. I spent 45 mins pulling it off, applying the spray and reapplying. I finally had to clip off the edges (with uneven edges collecting dust) to just have it applied on the back body. Better sell only the back portion of the protector without the edges. Especial this round countered phones.

Did what it was supposed to do and saved my phone

Terrible! The back skin was the most difficult to get onto my iPhone! It continuously got stuff in the wrong places. I was as careful as could be, but this was just too much to handle. I'm getting rid of it. The front shield was okay...nothing special that I can see, yet. The front shield saved this rating from being even more terrible.