Elite Vision Advanced Automotive Accessories - HID/LED Resistors H4 (9003)

Ordered H7 resistor harness, so I wouldn't have to cut or splice anything. Well, I'm not sure what I got, but it wasn't H7, looked like 9006 or something similar. Ended up having to cut and splice my wiring, which was the whole reason I bought these over bare resistors, but they did work once I got them spliced into my factory headlight harness.

HID/LED Resistors were relatively easy to set up. plug and play and then find a mount appropriate to avoid melting the plastics on your vehicle since the resistors do get very hot. However, because the product is cheaply made, what I noticed is that the electrical tape that binds the wires to the metal well eventually melt, loosen, and separate which will result and flickering and the aftermarket LED headlights you purchased to stop working. Now, I have tried soldering the wires to the metal part that didn't work. I tried re taping it that didn't work. Overall, I believe that the design of these resistors is not good. Or rather the quality is so poor that it makes the device useless and ineffective. I used mine for roughly 2 weeks before I noticed my left led headlight was Flickering. Afterwards, moments later, that headlight went out. It was nighttime so I checked the following morning and that is when I noticed the separation of the plastic or tape from the resistor. I am disappointed and will look for another brand to purchase from.

Works well.However longer cable would be appreciated. Mounting hardware would be nice as well.

If you're installing these be aware that they get VERY hot. They need to be mounted to a metal surface (usually outside of the headlight housing).If i'd designed them, i'd have left the wire sets to the resistors off since they're not really long enough to reach anywhere. I had to make jumper wires so the resisters could be attached to the metal frame.

These are cheap for a reason. Do they work? Yes. The parts are similar to other led resistors. Both male connectors were difficult to align the pins in the female connector. One when I pushed the two together actually pushed one pin out exposing the poor crimp, with several wire strands not in the crimp. Since most wires were I just put the pin in in place and completed my install, afraid if I looked closely I'd be taking all connectors apart and redoing them. Like I said they work, this project is done.... next time I get some other brand.

Decent quality. Got these H4 (9003) adapters because they were cheap & picture showed them to have 8 ohm loads... but adapters came with 6 ohm load resistors instead

Item description clearly states these will fit a 9005 headlight bulb when in fact they do not. The pins and receiving end on a 9005 bulb and harness are spaced about 2 millimeters farther apart than these resistors so everyone trying to install these and complaining that the pins are bending or breaking, this is why; Looking at the picture you can see the female end of my factory harness is circled in green and the female end of the item in question is circled in red. I used the female ends because it will be easier to compare. The male ends are the same and also do not match up. This item is set up for an H11 bulb conector and harness not a 9005. Also I didn't get it until 3 days late.UPDATE: Part was packaged incorrectly. Part was taken in return and the correct part was quickly sent as replacement with no questions and at no charge so changed from 1 star to 3 stars. Thanks.

I’ve had aftermarket LED lightbulbs and got “Lowbeam lights out” message even with resistors installed. With this, that message is finally a thing of the past with this. The orange metal part does get EXTREMELY hot, so be sure to wrap it with a heat sleeve.