Amana ToolCarbide Tipped Countersink Drill Bit with, Ball Bearing Master Set, AMS-620, 10-Pc

Should have bought this first. The cheap ones are bad even on the first hole. Have been giving this some use and after several hundred holes it is still like new. I use it on an impact driver and only have tear out if I go full speed and press hard. Same thing for the non maring ring. It spins easily and will not leave a mark if you take it easy. If you press it hard into soft pine you will dent the wood. Leaves nice crisp shoulders for plugs. Didn't want to buy it because of the price but am glad I did. This one is a keeper.

I can’t tell you how many different countersinks I’ve have had, and have. But these are my go to countersinks now. I am a custom, home builder, and cabinet maker. And these are by far the best counter sinks I have ever used. I wish I would’ve found these years ago. Now I have doubles in every size that they sell. I will say they are not the cheapest. But they are by far the best. Watch out for the look-alikes.

Good kit for doing what it says - the plug planer does a nice job - don't throw out your sandpaper yet, but after doing 50 plugs in a birds eye maple floor surround, it is still performing better than most gizmos like it, easier to use than a saw. Counter set is better than most, though that is less surprising.

Must have for cabinet makers/woodworkers. Yoi need this! Top quality.

Countersink is great. Plug cutter not so good. Shattered after low use and little load.Amana tool (Frank) was unconcerned with making it right. Every excuse not to even look up the sale. No customer service was provided.

I bought the set to give me options for countersinking holes of various sizes.The bits work very well, cutting neat, clean countersink holes with consistent depths. There was now marring of wood on top.However all the pieces came individually packaged. It would have been better to get a container designed to hold each piece in place.

100%

If you think that you can simply insert 55202 - 55626 into the depth stop 55227 or 55294 , it will NOT. What a total waste of money. I needed a longer drill bit so I was going to use 55626 and pull the bit out longer. Instead I had to swap the drill bit itself. Is it a huge deal, no. But the additional countersinks are useless to me without the depth stop. Ugh