1.54''/1.93" Height Heightening Bracket Scope Mount for Tactical T2 Red Dot Sight QD Scope Riser Mount

First off i will say, this was worth the money in my opinion, as long as your expectations are reasonable. Overall I was very impressed with the quality and i could see how this could pass for legitimate at first glance. My only complaint is that the shoulders for the bottom of the head of the screw to mate against to hold the mount to the optic are very small, maybe .030 thousandths of an inch because the hold for the threaded shank of the screw is very oversized. Because of that, i would not expect this setupt to take a hard hit and hold zero. Other than that Fit and finish are very good, operation of the QD knob is smooth as well and the optic mounted right up very snugly even before screws were installed. I purchased this to see if i even like the setup before i drop the money of the real deal and im glad i did.

Very good mount. I got both heights. Seems solid and the finish is good. Fits my T2 footprint red dot perfectly.

The quality is almost identical to the real thing. It's holding zero and hasn't moved. I don't know what else you could ask for. I'll probably buy a few more if this holds up.

Does everything it's supposed to do

I bought this mainly to see if I’d like the 1.93” height. But it does not hold the optic steady so should not be used on real firearms.No matter how much I’ve tightened it down, it still moves when I pull the trigger so the POI is affected

Ok so I own prob 6 of the non clone mounts and yes there is a difference obviously but for the $ this one is great! Everyone that’s saying it comes off need to tighten the set screw in the back to make the wheel stiffer. I went as far as unscrewing it completely make sure not to lose detent and spring. Added a tiny bit of blue loctite and tightened down all the way and it feels like the OG.

Will not hold up to 9mm PCC recoil and will loosen

I used this knockoff to mount to my real Aimpoint comp m5, this would be a 5 star rating if they included a set of screws which they didn't. Other than that, it has the scalarworks logo on the bottom and everything.Edit: after 2 range trips with this thing, I had accuracy issues and later found out that it loosens up. I applied blue loctite to the screw and now it holds up but you lose the QD function. You get what you pay for.