Bosch 0232103064 Phase Sensor, Cramshaft

So my Mini developed a misfire on all cylinders, jumping about on the scantool. So I bought new coils and plugs and it made no difference. Someone online suggested replacing the cam sensors so I ordered these Bosch ones as they're a proper brand compared to a lot on here and very well priced. It took me about 3 minutes to install them and the misfires have completely gone.I would absolutely recommend these sensors for anyone needing to replace theirs.

2005 Volvo s40 2.4i petrol struglle few times with start, didn't always run smooth or sometimes bit lacking power.After failed attempt on start Engine Check light came onPurchased OBD2 scaner and error code was P0190 Fuel Rail Pressure Sensor A Circuit.Quick search on google for people experience and it was possible that sensor could fail or its wireing or somthing with fuel pressure system: pump etc. But most people changed sensor and problem went away. Had a look around wires all seemed ok. I have purchased this one because it is exacly the same part number as original one on car even if amazon says it isn't compatible with my car. Sensor came next day it was identical to the BOSH one on car apart from missing small volvo logo. Replacement very easy. Undo plastic colorful cap on righr side looking aft from fuel rail. Put cloth underneath and using screwdriver press tyre like valve to release fuel pressure. In the left side looking aft gently unclip and slide timebelt upper cover for access. Undo electric connector. Put cloth underneeth sensor as some fuel will come out. Undo 1x T25 torx bolt holding sensor and wiggle out old sensor. Install new one. Connect electric connector and timebelt cover. Start the car. Car worked perfectly and problem went away. Time for cup of coffee.Did now nearly 2000 miles and problem didn't came back.

This is the 2nd one purchased. The other was 4 years ago.It's for a Mini Cooper S 175bhp R57.So simple to fit and used my own diagnostic tool to locate the issue and once fitted, clear the stored fault codes.It seems OK... no misfires now.One bolt to unscrew and wire harness to unplug. It's right at the top of the engine. Really simple to replace.Fitted several weeks ago, running smooth.

Car ran better after replacement

Great replacement part for my car. Prompt delivery

Bosch again haven’t let the side down, I bought 2 for my Citroen C3 Picasso, some cars only have one, replaced both of them as they as old as each other. Fitted them in 5 minutes, reset the engine light and work perfectly - buy cheap, buy twice

All seems well so far. The original sensor lasted nine years and its replacement lasted less than three years. Time will tell.

Resolved cam sensor faults on Peugeot 207 1.4vti position A and B.These are the best