REEKON M1 Caliber Measuring Tool for Miter Saws – Eliminates Need to Measure & Mark Materials, Reduces Cut Time and Increases Safety, Measures Flat & Round Materials

Love it, Love it. Saves time makes projects go faster. No more measuring 2 or 3 times and 2nd guessing yourselfIt's so easy to use. Did I mention I love it.

Good Product

I'll give you all a moment to stop gigglingThe Reekon M1 is one of a few items over the past couple years that I saw used on Youtube that turned into a serious game changer.====> AS LONG AS YOU SET IT UP AND CALIBRATE IT PROPERLY! <==== Make sure to verify that your blade kerf is set correctly in the M1 or every cut will be slightly off.I have a Bosch GCM12SD Miter saw and quickly found out it was not immediately compatible. My fences don't have a proper spot to clamp onto so I had to purchase their adapter fences and mount them first. Annoying yes, but not a deal breaker. In reality i maybe could have researched that but I was a bit too excited. Either way once you get the blade kerf dialed in and your first calibration cut out of the way, you are on your way to perfect repeatable cuts. Its also super portable, I brought it with me to my Brother-in-laws and mounted it on his Metabo miter saw while helping him build a fence.Pros: Easy to read display, super accurate, vastly speeds up my cut lists, and comes in a nice foam storage case.Cons: For the cost they could have included the 2 AA batteries needed, make sure the piece you are cutting doesn't have major depressions or knot holes in the path of the measurement wheel ( the wheels distance traveled will be different from the straight length ), and you may not know if your saw is 100% compatible until you're there with the device in hand

Been using this thing for few years now. Simple and easy to use. Glad I purchase makes cutting to size great and if so it right get same length all the time. I would highly recommend if your looking but oneI would buy again

If you are doing one or hundred cuts, this is nice for continuous accuracy.

Follow Up: since my first review, Reekon reach out and offered a refund. They then requested my address. Once I supplied my address they stopped responding. I believe this is a scam of sorts.This tool is very inaccurate. Never get the same measurement twice. All hype no accuracy. Save your money.

I couldn't belive until I used it. The accuracy is so high and easy use. The material is high quality. I hope their new Tape measure comes out (the chip one) and I can ordered it immediately

I was not happy with this product and ended up returning it. I find the claims of vast speed improvements from using this tool to be overblown.Perhaps it's a "skill issue" as the kids say, but I had two main problems with this. First, you have to make sure to carefully slide the entire length of the board you are cutting under the wheel, making sure to keep the board against your saw's fence in order to get max accuracy. When you are making long cuts and sliding the bulk of an 8 foot board down the fence, that's easier said than done...at least for me it was. I found that it was faster for me to just measure with my tape and mark my boards, then I can put the boards quickly against my fence with my mark already near the blade.This also has an accuracy of 32nds of an inch. Typically, you would think that's a good thing. But as you approach your desired cut length, the finesse required to ease up to your measurement as the 32nds tick by was just too much for me to be efficient.I am an absolute novice, so if you are experienced, your experience may be different than mine. I cannot complain about the accuracy of the tool. Even though the calibration instructions were a little vague, I was able to setup my kerf on the device, and I was getting accurate cuts. My main complaint is simply about the purported time savings, which I did not personally experience.