ParaBellum Designs Universal Speed Loader – Magazine Loader for 9mm .40 S&W Pistols, Easy Glock 19 Glock 43X, and just about every other brand/Mag Loader, Fast Reload, Thumb Saver – Made in USA

This loader is very easy to use once you get the hang of it, which only took me about five minutes. Suggest watching the video instructions from the card that comes with it. Scan barcode, watch video and then understand which spacers to use for your mag. Once you understand how to use it, it’s easy and fairly quick. Definitely saves your thumb. I would highly recommend it for first time shooters to advanced. Worked perfect with my Sig 320 M17 10 round mags.

A couple of minutes and you'll be loading quick and easy. Works on multiple magazines.

A little hard to use at first but once you figure the technique it's a finger saver

I have the Uplula, ETS, and this. I use the Uplula at the range since it can easily be used while sitting in the seats (no table). I could not use the ETS one at all - it seemed that the amount of force necessary was either going to plunge it through my chest or break the loader. Perhaps I didn't have the magazine in properly; that seemed a bit hard to do as well. This one (Parabellum) works like a champ. Take a minute to figure out the correct spacer you will need - that does wonders. This one is definitely my favorite and I will likely start keeping it in my range bag. Also, I love that the magnets hold everything securely and that it is made in the USA.

I am in my 70's and have arthritis in hands which makes it hard to load magazines, especially high capacity. With a little practice and following instructions, this loader is a GOD send and a dream for us older guys. A must have at any price. I would advise anyone to have this in their arsenal.Sincerely, best money you could spend on a loader!!!

I’d describe it as an “easy loader”. It works, and the 3D printed design is cool. It takes some practice getting the rounds to line up since they don’t want to roll straight in the chute. I have to adjust them a few times per mag. It’s a thumb saver more than anything.

While this is 3D printed, it is solidly made and well thought out. The ammo loader is held to the body by magnets and comes off easily. You run it over the top of ammo and it pick up the bullets. You then slide them out into the feed ramp. The provided “spacers” (see pics) make it easy to use a variety of magazine sizes (and they store magnetically underneath the body). It does take practice to get used to loading magazines, but once you get the hang of it it is quick and easy.

I had trouble using it at first then I realized the stop bar was broken. Glued it and now works better than any speed loader I've ever tried!