PGN UCP205-16 Pillow Block Bearing - Pack of 2 Mounted Chrome Steel Bearings with 1" Bore - Self Alignment

GREAT and 1/3 the price IT WAS 169 $ EACH at the bearing place install and working great THANK-YOU

I purchased a two pack of these pillow block bearings for a flat sander project that I had just finish designing and I am now in the process of building. I am always amazed at these bearings and how well they work and how cost-effective they are I have mounted up my large 22" long contact Drum between two of these bearings and they run smooth as silk. The bearings seem to be very well built and are double sealed and should hold up well in this application I have used similar bearings from this company before and they have lasted a long time. I highly recommend these bearings and would use them again. Thank you

Good little pillar blocks for the price.

PGN - UCP206-20 Pillow Block Mounted Ball Bearing - 1-1/4" Bore Review edit 07/07/2021 I have used several of these BRG's and have had on problems with miss alignment, I have read other reviews that state the brg,s are out of alignment, These are self aligning bearings if the are not able to self align I would check and see, That if it's not a manufacture problem on the bearing but on the final users design as far as the alignment goes, there's a lot of room for the final assembly to be corrected buy the bearings ! Great Bearing's, Excellent price, I used these 1-1/4" bearings to attach 2 - 7 foot gates to the framing of my shop to keep my explorer dog from exploring. ( also keeps his furry friend's out ! I used 1" ID. Black Iron pipe for the shafts, turned down to 1-1/4" OD, works great, but a little over kill on the bearing size so when I built the gate for the 12 foot door on the other side of the shop I used PGN - UCP205-16 Pillow Block Mounted Ball Bearing - 1" Bore with 3/4" ID. pipe Turned down to 1" OD. The gate sections are fence sections that I purchased from HFT many years ago work great for larger dog's, maybe not so good for smaller and pups.. I have just reordered a additional set of the 1-1/4 in to make a 16X4ft automatic swing gate for my driveway. (Will write a review on how that turns out shortly !!)

Nice, appear well made for my gokart project

Nice and solid bearing seems to have nice preload. Will be using it on a diy wood lathe. Bought .625 bearings. I have a ground rod that’s exactly .625 and the fit is a nice sliding fit. So bearing must be ground over size by about .0005-.0015. Initially I was dismayed as my bar didn’t fit but there was a slight burr on my bar where it was cut. Took the burr off and it slid right in. I will definitely be using pgn products again. Very mind blown with how good this purchase was. Some people said in comments that bearing was shipped as metric to them. This did not happen to me, so it may have been a mistake in the past.

works great no concerns

very good product and seller