KBS Coatings 4402 Satin Black Rustseal -1 quart, Covers 50 Sq Ft, Proven Rust Prevention

I bought the black Rust Seal for my snowblower and used Por 15 for the orange part. This product is much better than Por 15 - the next day is was hard and I could sand it and apply a second coat. It is a true moisture cure urethane. 2 days later and I can’t touch the orange. Nice product

Great product! Exactly what we needed!

Had my doubts about coverage I did not prepare my surface as well as I could have would have taken days. But once applied with a paint brush went on smooth and relatively thick. Covered everything i wanted. Used in on the floor board of an old sports car man is it tuff stuff. Helped my kill mat stick firmly to the car would buy again next time. Excellent value over others worked great.

nice coverage, holding up well

Works good and gives a hard durable surface. Used this on a car trailer frame. I like that it can be brush applied. Bought disposal brushes and mixing cups off Amazon to work out of when painting, then just pitched them when done. Pour out only what you can use in about 10-15 minutes (depends on humidity and temp). Be sure to seal the can as recommended with plastic to prevent the lid sticking. Gave it 4 stars because the galvanized color shows the brush strokes from being applied. I tried thin and thicker single coats. Thin coats showed the brush strokes much more noticeably. Was better with thicker coats but then there was the occasional run. Also tried 2 coats but results were about the same. Looks good from 10 feet away but not as good up close. Did not have this issue with the black color I used previously. It flowed out nice with no noticeable brush strokes or runs.

This wss as exactly as described, works well, excellent finish. Best value for your money.!

I fine this a Great product! Package for shipping needs to be upgraded as the can dent and cause problem when revealing. P.s always use a 1mil plastic bag one the lid so you can remove it the next time.

I opened the can, used a small amount then made sure the can and lid where spotless clean before resealing. About a week later I could not reopen the can. See attached pics. I had to drill a hole into the lid and can then pry open the can ruining it. I poured the leftover paint into a jar which I hope will seal well enough to preserve it. I wasted a fair amount of the product because of this and needless to say it is expensive. I'm very disappointed.