HandAll Beavertail Rubber Grip Sleeve for Glock 17, 17L, 17MOS, 19X, 22, 24, 31. 34, 34MOS, 35, 45 (Gen 3 & 4)

I like these for all my guns. The grips are hard to get on but its a great thing as they won't move around. I recommend a hairdryer to heat it before installing. And the secret is to get it on and than heat it a bit as it cools off as you are installing. Its a comfortable grip and doesn't get tacky over time. The fit ia good. The black is a perfect match to Glocks. The quality and durability is great.

Great fix minor trouble getting it on but overall great fit.

Adds a little bulk but fits perfectly adding comfort and additional grip.

Nice grip. I have 4

The Grip adds thickness and better control for me . I have large size hands , It was worth the effort to get it on . I have to say that the material is top notch as it held up to all the pulling and stretching to get it on . I followed Hogue's instructions on putting it on (check Utube) . I was not able to use the cut out plastic slide pieces , I did heavily and repeatedly soak handle and grip with window cleaner also I used a tea pot to boil water and dipped Grip in and stretched while hot (use caution can burn your hands) during the process I dipped grip and Gripstock in hot water to keep it soft and stretched with fingers and palms of hands. I dried out magazine well and used hair dryer to evaporate any moisture also I kept Glock upright to keep out water. Just have patience and it will go on . Was probably more difficult on Gen 3 do to finger bumps.

So, I did heat the grip prior to install but only in hot tap water for a few minutes. It took me close to ten minutes with some work, but it was worth it for me. I concentrated on getting it over the lower swell at the mag-well on the bottom of the grip and then worked the backstrap up. Just keep working it alternating front to back of grip. I also worked it from inside while stretching grip then gripping and twisting from the outside. This will try your patience and hand strength but once on feels good and has great grip. I have another Hogue grip on my G19 and really like them. It will fit G21sf Gen 3, you just have to work it. Good luck!

These change the grip on slick Glocks. I love the feel. I use on my work gun. Great for when it’s hot or really cold. Need to heat up and possibly use dish soap but they go on. Probably impossible if you don’t heat in warm water first.

The Hogue Handall grips are excellent products. Pros: They definitely do a good job with the grip texture on them, I never feel like I'll drop my piece when using them and they offer a bit more thickness which I prefer. They make them for a huge array of models, you can usually find one that fits what you have even if it's not explicitly for it. For instance, I put this one on a PSA Dagger Fullsize and with a bit of work it fits and feels great. Definitely dampens felt recoil, you can get a bit more hands on time before your wrist really feels anything. Cons: Only complaint with these is the same as most people have, they are difficult to get on. There is a reason for it though, you don't want it coming loose or twisting around when you need it to stay put. So having a tight grip, though a pain to get on will be much better in the long run. Very very rarely you might get one start to split but it's not common and usually happens if the wrong one is used on your piece. Overall I will generally always recommend these unless you have smaller hands and don't like the slightly chunkier grip.

Excellent

Lors de la commande j'attendais vraiment un pistolet a air comprimé , et le résultat de la commande est seulement la poigné de l'arme ( pas très explicite) .