Winjet Compatible with [2005 2006 2007 Honda Odyssey] Driving Fog Lights + Switch + Wiring Kit

Great Deal, unbelievable price. This was the best price that I found. Fit up and installation were perfect. Did not use the wiring harness, relay, or switch, as this was strictly fog light replacement, not an add on installation. I recommend this kit over others. You cannot find the lights alone at a better price than this entire kit. Once installed, clarity and brightness were superb. For my job, only one light was damaged from the collision, but with the damage and install the bumper skin needs to removed so a recommendation here; REPLACE both lamps, although these are a direct replacement and the same size as the factory lamps they have a slightly different appearance, so if u want uniformity, replace both lamps. This only takes another 5 minutes of labor. Would definitely purchase again!

5 star because they look stock and All hardware made it easy to mount. Everything was exactly as advertised. Very very happy with how they look. Easy to install with hardware provided,even though instruction would have been realllly nice to have. Every bit of it looks like Honda did the install except..... I did it for much less. My Odyssey didn't come with the lights so I had to cut the holes. No biggy with correct tools and confidence. Downside: Does NOT add any night time visibility. I would love to know why they are very low light output, can hardly tell that they are on at night.... look to be more of a daytime running lamp ( even with a bulb upgrade). My headlights are PIAA and driving lights are not. They look good from outside.... From inside.... I've had much better inexpensive driving lights. Bottom line- I wanted to fill the bumper spot with the correct light and this was a very great prices option and very well built. Going to add a second set of lights behind bumper for our night driving on back roads.

These are very close to stock, my 06 odyssey ex didn't come with fogs. I modified the wiring kit that came with the lights by adding another relay to shut them off when the high beams come on. My odyssey was prewired with two wires going from the drivers side dash area to just under the under hood fuse box, I used those to run to the switch and connected to the high and low beam fuses in the under hood fuse box. I also wanted my fog light switch in place of my vsa switch so I used a dremel with a sanding drum to round the corners off the hole in the dash so the switch would fit. Also sanded off the plastic bar thing on the side of the vsa switch that prevented it from going in the far right slot.

Fit was good, not sure if my bumper was out a little or the lights were off but they did a great replacement for the OEMs that has been destroyed by 100k of road miles. I hope I can get the same from these.

Is not a plug and play kit if you already have fog light, it might be easier if you don't have the fog light and are just adding. I installed on 2007 Odyssey touring but the bracket that came with the lights don't fit with the OEM bracket that stays on the back bumper so I swap the old OEM bracket to this new aftermarket housing lenses, it works but the lights seems slightly smaller and leave a gap on top of the light, remember to adjust the height of the lights after you install them.

Great replacement for pitted or broken OEM fog lights. Was surprised to find that this was a full install kits with switch and wire harness. Fit perfectly. Nice and bright again.

These came with everything including the bulbs and fit great.... the price was also right. By the way there is a slight half circle at the edge of the plastic splash shield under the bumper cover in the area below the fog light. You will need a long extension and I believe it was a 10mm socket to take our only one bolt that you find straight up several inches to remove the bolt. Then you pull the inner edge of the light fixture out to remove it.

After market product so it didn't install as easily as name brand. Took two people to install. Works well once in!!