120V LED Strip Light Dimmable by Wall Dimmer Switch, Waterproof IP65, No Need LED Driver, Warm White 2800K 110V LED Rope Light, 300 LED 16.4ft LED Tape Light 115V Under-Cabinet Light Flexible

Have used this in my own space and for customers. Getting adhesion down can be tricky depending on how you are securing/hanging these. I would not trust adhering these directly to a surface and expecting it to hold unless you are working WITH gravity, i.e., you are securing them to a flat surface and emitting light upwards. Wish they were color selectable but the option of dimming without any add on is enough.

There are a LOT of LED strip lights, but most are DC powered (through inverter). I however wanted water proof lights that I could install under the benches of a sauna and control through an Alexa controlled AC dimmer switch. There were very few options, but these worked perfectly and dim to a very nice low light ambience, to a very bright light up the room level. I bought 2 sets of these, and cut them to size to fit my Sauna as needed. I can't speak to how long they will last because there are just a few weeks old now, but I can't imagine any reason that they would not work long term.

I had such a hard time finding something that was 120 bolt and able to use with a standard dimmer switch. We installed them in an indirect channel in our cabin. They work great down low as night light or cranked up for nice light. The only know was the adhesive tape back. The strip the you were to remove before installing just fell off so that made the need fo an extra set of hands during the install.

It was ver easy to install and the quality was more than i have imagined.

I have an older mini fridge that had some small tubes of incandescent display bulbs, and one of the strings burned out. I searched diligently for LEDs that would fit in the space (cuttable), and were also 120V. I was successfully able to cut these to fit, and solder the original fridge leads to the ends. I hot glued the ends closed, and the adhesive backing cleanly stuck these to the ceiling on the fridge. Now I’ve successfully done an LED retrofit off my old fridge! Considerably brighter than the old display lights, cool temp, and hopefully will last for many years.

Bought 5 of these for my kitchen soffit, to replace some aging LED rope lighting which was starting to fail. I have a 2 gang outlet in the soffit, controlled by a Lutron wall dimmer (sorry, don't know the exact product number, but similar to the LECL-153P), which worked just fine for the rope lighting.I connected 3 lengths of the Enersystic and plugged them into one side of the outlet; connected 1 and most of another length and plugged them into the other side of the outlet.I had heavy flickering using the existing dimmer, so ordered one each of the 3 recommended dimmers (Sklark and 2 versions of the Diva. One of which cost ~$70). Tried all of them and still have flickering. Very noticeable flickering, very pronounced at the lower light levels.I'm probably going to write the whole project off as a loss - don't think that I can return any of this stuff because it's been used.The lights are nice and bright - almost too bright - for the kitchen without being dimmed.The tape that comes installed on the light strips is really not that great. I wound up using 3M outdoor double sided tape to hold the lights in place, using one 1" x 1-1/2" piece of tape every 16" or so.A fair amount of work for an unsatisfactory result.At the moment, I'm still using the old rope light while I look for another solution.

They were such a pretty color but stopped working after a week. 😭

Great lights! The 120v makes it simple and you can use connections from both ends if you hardwire, you could use a middle section if you solder to that piece.