Castin' Craft Mold Release spray

This worked amazingly! I used this on a PLA mold with UV resin and it did exactly what it was supposed to, the cast popped out with ease. I've used other release agents that didn't work with this process, so I'm very glad I bought this one!

Perfect for hobby resin casting! Mold breaks away easy and comes out with a professional quality surface!

Seems to work better if you can follow directions which are to allow the first coat to dry - takes about 5 minutes - then spray another and let it dry. The only potential problem with this method is that I noticed that where the spray would pool, in the point of a pyramid mold for example, the very tip of the cast looked scratched and I'm not sure if that is the spray's residue that collected there and became part of the mold or if that was one of the crystal points I put in the tip of the mold, but I happened twice. I would be careful not to allow it to pool as you may end up with an undesirable surface on the cast.

Just follow the directions--no problems, worked extremely well, and it was cheaper than the local craft store's version.

I found it works best with lower qualityor thinner molds. Thicker, higher quilt molds seem to just soak it up and the relieving bubbles is impossible, resulting in holes in the resin peices. I followed the directions to a T and various application methods besides just shaking and spraying, and when I don't use it I have none of the problems previously mentioned. Great as a mold conditioner though

ok i always tell the truth my first time useing it it seem to work very good.

Works Great!

Works well for popping cured resin out of small or plastic molds