FEL-PRO MS 93317 Intake Manifold Gasket Set

No leaks yet after about 1000 miles

Fixed my vacuum leak issues. I still use some RTV black on my water jackets and bolts and the ends of the block. These are the best gaskets you can buy. Does not come with the end of block gaskets. But you don't want to use those anyways. Just use RTV black and be patient and wait the 24 hours before starting your engine and it will last a long time.

Arrived in a box too small, so they were all creased up and bent. Hasn't compromised the seal though. And if they leak, I'll update my review.

Good gaskets as Fel-Pro gaskets usually are. On this order I did not receive the distributor gasket and silicone that are shown and listed to come with the order. I'm sure it was just whoever packed it. Just be aware of this as I needed to buy locally to finish the job and couldn't wait.

About same price of auto stores .Holding up so far

Perfect fit good quality!

In the 3rd or 4th picture it shows the rubber end seals.... "we found that was a lie".RTV and not enough of it, make sure to get some extra before you start the project.

Gasket instructions were good. Fel pro is good quality but that small rtv that it came with was *just* enough for the front and back areas on the motor. Be sure not to over do it on one side before doing the other, or have some more handy

Changed my 26 year old intake manifold gaskets and used these. Had to stick them in place with anaerobic sealer not because they needed it, but because the are a little bit mobile when setting the intake down. I didn’t want to risk any gap in the RTV sealant on the front and rear edges . Just enough RTV for the job. Used Felpro a lot and never had a problem with their quality.

better than the other brands, especially for a 350 sbc. these gaskets are thick & squish down evenly for a perfect seal.