1" Yoke 10" Laminated Tire Finish Mower Wheel Assembly 2 PACK

I used these caster wheels on my bush hog and they fit perfect! They are very heavy duty. I am very please with the purchase.

Great product professional grade and performed extremely well 2 years of use and sill working Great was 1/2 the cost of my OEMUsing 2 sets on my 3 point finish mower on 7 acres

I have a very hilly 12 acre property and use my bush hog more like a finishing mower. Problem with that is the tail wheel and leading edge of the bush hog will often rip into the ground if you're not constantly adjusting the height.I installed these wheels on the bush hog so that it can just sit on the ground and trail along more like a finishing mower without having to fiddle with the height constantly. They are very heavy built and so far they are holding up excellent, even being used on more rugged terrain than they were probably intended.For someone with a normal finishing mower they will probably last many, many years.

These wheel sets fit my Landpride AT2572 just perfectly. The adjustment spacers are also perfect. The rubber part of the wheels seems to be rugged time will tell but I am thinking they will last quite awhile. I think that the price that includes the spindles is very good. I have massing around with different flat free tires all of which turned out to be a waste of money. This maybe the best way to go!!

I used these to replace the pneumatic wheels and tires on a 3 point hitch mounted 5 foot cut finish mower. They work perfectly and fit without modification.

I have a pretty new Kioti Finish Mower deck and ALL of the wheels are falling apart. Big chips in the rubber wheels and one actually broke off the rim. (pretty disappointed with the manufacturer on that one) Otherwise the mower deck is pretty good.The wheels on the mower deck are 8 inches high and rated at 300KG per wheel. I had decided there is no way i was going to replace the 2 year old wheels with the same thing since they failed with hardly any use (under 50 mows). I was concerned that a 10 inch wheel would not fit the machine correctly and would hit the deck while turning or backing up.I gave these a try.The fit and have clearance to fully rotate. Tested them on over 15 acres of grass. No problems. No divets/tracks. That the good.The bad. My deck has bushings that the wheel shafts need to fit in. The bushings are pretty tight tolerances. One of the shafts was deformed by around 1/32nd of an inch where the securing pin passes through. I had to grind it down a little bit to get it to fit. The other shaft was just fine. Since you cannot easily put this thing on a lathe to true it up, you need to be somewhat careful in doing this work. Overall this was a pretty minor flaw but something the manufacturer should pay closer attention to. It did add about 1 hour to the installation task. The second one took only 5 minutes because it did not have the same problem.Manufacturer.. if you are reading. QA should do a test fit in a receiver that has top and bottom bushings and a grease fitting in the middle. That simple test would have probably failed and would only take like a few seconds to do before welding up the wheel assembly... and more importantly, while it is trivial to fix.Update----------------I ordered a second pair of these and had the same issue I had with the first. One was not entirely straight. It was very very close and has since worked/worn itself in so that it spins like it should. The first pair was worked flawlessly since they worn in. No issues in over two years. The tires I replaced were destroyed in less than two years....so these are way better than the originals.

My husband bought this wheel to replace one on our tractor finishing mower. He says it is quality material, was easy to install, and works perfectly. Great product, great purchase.

good product