VViViD+ Premium Charcoal Grey Satin Adhesive Vinyl Wrap Roll (1ft by 5ft)

Great quality easy to install if you are patient. Able to replace when rock chips occur.

Good material, easy to work with, stretches well and it was cheap! Does its job, Holding up great these last few months!

So to be honest and perfectly clear, I did not use this as I imagine most people would want. I needed to replace/repair a decal on my camper. I cut what I wanted and applied it as you normally would. Has been on the camper outside in the elements and is holding up nicely! Wouldn’t hesitate to purchase it if needed again but hopefully I won’t. I was repairing the camper from an “incident” that happened on a trip home…

Ended returning because I didn’t have time but the quality was amazing

Easy to use, provides the effect we were looking for

Bueno

This product isn’t worth spending your time or money on. The color is nice for a gunmetal gray. However, the product doesn’t heat or stick to any surface you try to apply it to and it tears very easily. It doesn’t stretch and isn’t worth the hassle.

If you’re looking to match your Ford that happens to be carbonized gray metallic, the this is perfect for ya!!! Material is great and easy to install and work with. Great match!

Works great.

This is the bomb! Love it! When I get the bike finished I will post a pic. I have both this and the carbon so the bike will have the carbon spine with the charcol gey and yes I forgot to mention I have the gun metal patern as well which will alo be in the design! Sweet! SEND IT!

This is a great quality product. I bought 3 5x5 ft sheets and all matched. I am a first time user so wrapped my hood, roof, shark antenna and gas cover. The wrap is super easy to install on areas less than 2ft deep and the air release works. I was able to lay without any air bubbles Trying the hood was more of a challenge and needed 2 people. When I’m heated the wrap, I wasn’t able to release the smaller bubbles and had to stretch to prevent creases. However it self healed when I reheated so that was great. I saw some YouTube vids on people using water and soap on the vinyl to smooth and minimize scratches as I did create some scratches I couldn’t heal Stretching the wrap for the antenna was really difficult, perhaps since it was a thicker vinyl. I had some creases at the bottom that I couldn’t remove and was too tired. In any event this is a great product but perhaps a bit too thick for a novice user on large areas and a shark fin antenna so can’t fault it. I may try the 3M next time as I hear it is thinner.

Good product.

It's ripped and cracked Wasting money,