Rapid Tac II Application Fluid 4oz | Formulated for Specialty Films | Promotes Faster Bonding | Cold Weather and Glass Use | Allows Re-Positioning of Decals, Stickers, Wraps

So glad I came across this product for applying vinyl. It cleans the glass well and makes application so much easier.

Works great for applying vinyl. Smells pretty good too

I was helping my brother install some vinyl badge and wheel overlays on his Ram and saw a video using this product. Well, it got me thinking about some Lux tail light tints I had bought about 3 months ago. I really struggled with those because they would stretch and warp a bit as I tried to install them and then they’d be nearly impossible to align right. So I had quit on that project but decided to try again with this in my arsenal. Ordered another set and using the slippery fluid made the alignment much easier and gave me time to properly align the pieces without any stretching out. Was very happy with the results. A little goes a long way so I should have bought the smaller container and saved a few bucks but all in all I’m happy with the product.

Good for surface prep and installation of vinyl graphics on cars.

First off, the product works. I used the RapidTac Prep first, then RapidTac II. Yes, it does allow one to position graphics then set them. However, it does not let you slide them around, you have to lift and re-position. It only is a problem with very large graphics. I have used this on race car graphics that were large and I "managed." In the future I will most likely use Slide-On from Phoenix or Classic.

The Product is what it says to do as I want it to for use

Awesome stuff.. don’t know and not care what it is. It works great with vivid pro carbon wrap and that is all that matter to me. The wrap was expensive, so don’t skimp and use “other” stuff. It’s been 3 months since the install and the van has been outside and the wrap still looks freaking awesome. I tend not to rate mediocre only really good a and really bad products. Nuff said.

I'm sure this works great. I bought it to put new vinyl over my 1978 kitchen cabinets. This product is not recommended for indoor use. The whole MDS is not shown in the description. Here are the warning statements. This is useless for work indoors. The product description should have all of these warnings. Warning Hazard Statements (GHS-US) : H319 - Causes serious eye irritation. H336 - May cause drowsiness or dizziness. Precautionary Statements (GHS-US) : P261 - Avoid breathing vapors, mist, or spray. P264 - Wash hands, forearms, and other exposed areas thoroughly after handling. P271 - Use only outdoors or in a well-ventilated area. P280 - Wear protective gloves, protective clothing, and eye protection. P304+P340 - If inhaled: Remove person to fresh air and keep at rest in a position comfortable for breathing. P305+P351+P338 - If in eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. P312 - Call a poison center or doctor if you feel unwell. P337+P313 - If eye irritation persists: Get medical advice/attention. P403+P233 - Store in a well-ventilated place. Keep container tightly closed. P405 - Store locked up. P501 - Dispose of contents/container in accordance with local, regional, national, and international regulations.

Excellent product

Great for sublimation

Putting on a wrap for a vehicle

I used this instead of an alcohol-based dilution to install some paint protection film and found it to be more problematic and less ideal for that purpose. It may be more well suited for vinyl decals/applications. I switched back to alcohol with better results.

I found it worse than windex