KXLIFEFlexible Ceiling Curtain Track, Ceiling Track for Curtains, Curtain Track Ceiling Mount, Curtain Rail, Ceiling Curtain Rod, Sliding Curtain Track System (8 ft)

I wanted to rip out my RV shower surround enclosure and replace it with a shower curtain to give us more elbow room but my shower stall is an odd shape and I couldn't find a shower rod that would work. I stumbled across these and knew immediately that this was solution. Now we have more room in my RV to take a shower.I followed as some had suggested to straighten these out. I held them infront of a heater and slowly bended them straight. I didn't get it 100% straight but it didn't have to be because I still needed them to be a curve. I was able to easily cut the rail to my desired length with a hacksaw. It did take 2 people to secure it to the ceiling without much hassle.

High build quality with a lot of length and space for customization. It’s extremely easy to set up with the instructions just make sure you have a drill!

The rail works great, but need one small improvement. If the manufacturer can attach the hook to the sliding ring and close the gap, that will be perfect. Cuz i need to use a pillar to close the rings myself or the hook will get off the slide if you pull the curtain fast.

Great Shower curtain system for my sit down walk in jacuzzi tub

Very pretty, good fabric and got here right on time

You're never going to get this to lay flat, that much is certain. I pinned this under weights for literally days, and it remained curved and continued to resist my efforts to put up. The hardware is included but super visible, but it seems like it holds the weight well and it's accurate to size.

Recommended! It's perfect for someone don't have shower room and just sink and toilet bowl. So I made my own shower next to sink where I can connect a shower spray. I installed it so fast on my ceiling, and attached all the accessories. It was perfect. It's durable and strong enough to hold the shower Curtains and using it everyday now.

First, people that are complaining are those that don't normally install much of anything. Complaining that a product is difficult to install is not about the product. It's about the user/installer inability and lack of experience. If you don't know how to install an A/C unit, would you rate the A/C low due to your lack of experience and understanding?My review is that the ceiling mount curtain rail is very strong because it's aluminum covered in plastic. Metal is typically supposed to be difficult to bend. If it were cheap plastic and nothing but plastic that was easy to bend, then the complaints would be that it doesn't hold up and is flappy.You MUST unroll METAL rail the opposite direction and allow it to sit (overnight is what I did). As a matter of fact, I simply kept bending it a few inches apart because rolling was difficult considering I purchased quite a few feet for my purpose. In any case, reverse rolling WILL NOT make it straight. It simply makes it more manageable to work with due to less roll.To get straight lines, you MUST install the brackets fairly close; I suggest at least 8" apart instead of the 12 to 16 inches the instructions say to do. The more and closer the brackets, the closer to straight you will get. The further the brackets, the more waves you WILL get (nearly unavoidable).Installing the rails into the brackets is best done by screwing the end without the plastic all the way in, and NOT screwing the plastic end all the way. Screw it most of the way to allow the rail to snap into place. Once you have a good amount of the rail installed, screw the end with the plastic.It works!