New Ziflex - Flexible and Magnetic 3D Printing Platform - High Temperature - Strong Adhesion and Simplified Removal (232 x 154 / Flashforge Creator Pro)

I have done about 10 or 12 prints now using this magnetic build sheet. They were all done using ABS at 235 deg C with a bed temperature of 110 deg C, using my Flashforge Inventor printer.It has transformed the way I work. I had to literally chisel off the prints before when I used the original Flashforge build sheet. Now they just pop off. It is so much easier.It was easy to stick the sheet to the bed and the bed levelling adjustment was enough to accomodate the additional sheet without touching the Z axis end stop.No signs of any degradation yet but if in the future it becomes worn it is an easy job to change the build sheet or even stick another surface on top. The magnetic part stays permanently on the printer.I have been 3D printing for a long time and I have gone down the route of printing on glass with ABS juice, printing on blue decorators tape, printing on kapton tape, using glue sticks.Forget all that now. This is the way to go.Update: I have now done about 30 prints with this build sheet. One large PLA print detached, so would benefit from a raft in future. All ABS prints were successful.