Field Tuff 18.8 Pound Fast Change Hitch System Category 1 and 2 with Powder Coated Finish and Complete Hardware for Home Improvement, Black

Installation was easy. I did buy some different bolts that were just a bit shorter. This helped when I was trying to keep the latch open with the loop retainer for disengagement of the implement. I have a kubota, other tractors may not need this modification. You will need a longer top linkage. I bought a 20 inch center segment top linkage and this works for all of my implements.

Overall it works as advertised but the side to side and up and down movement could use some work. It really should be an adjustable "sleeve" that fits over if and adjustment bolts to better line it up straight. But it does what I wanted it to and makes attaching implements easier.

All of the tapped holes[threaded],I had to retap them total of 10 holes because you couldn't screw the bolts into them,very poor product we'll see how it works on the tractor!!!Hopefully better than the holes,very dissatisfied with Tuff Brothers product and delivery....2days late!!!!

It’s durable, you just need to use it in very small, garden type tractors. It works great on my small Kubota, but I didn’t like it on my 50hp Kubota.

SO much easier to put attachments on the tractor with these. Considered Deere's quick hitch but not all implements are compatible so with these the only thing left to connect is the top link which is pretty easy. The only negative is they put the implement farther from the back of the tractor by a few inches so this affects the weight balance but worthwhile trade off.

I used these for about 4 hours with a box blade doing general road work. The bolts bent which allowed the quick hitch to flop around like a broken wrist. I adjusted several times only to end up in the same situation each time. Look closely at the picture these are only one sided so there is no inside support, other than the one inch bolt, to prevent these from moving around. Just not worth your time or money. Wish i could send these back but after only 4 hours they are beat to crap, the plastic (yes plastic) retention straps are gone as is most of the paint.

This system makes it much easier to line up the pins on the implement. There is still some work to do on the ground but you don't have to be levering the implement into place. I like this system a lot. Not all my implements have the hitch pins at the same width.It is easy to adjust the width of the lift arms as needed.

These fast change hitches work fine but they do add to the length of the three-point lift arms. They were a little difficult to install on my Kubota tractor but they serve the purpose and they are lower priced than the competition.