2" 52mm Fuel Level Gauge Universal Car SUV w/Fuel Sensor E-1/2-F Pointer Meter 12V

Took a little modification for a stock tank but works good. No complaints

Good parts and fits well

This unit was easily installed. It worked for about two weeks, now it is not working correctly. It jumps from 3/4 full to empty when the vehicle is moving. I see no warranty options?

Fit my Club Car. Had to use the guage that came with it cuz the original used different resistance values.

Gauge works but extremely cheaply made with the smallest possible studs and wiring. Sending unit is pretty average

Seams to work, biggest problem was calibrating the sender, the paperwork was not even close, gauge wouldn't read above half tank. Had to bend the float tube several times to get it to read correctly. If you are not mechanically inclined, I would not suggest this product. After using it for awhile, it started to make the gauge jump around at 1/2 full. Went with a more expensive one and it works much better.

Nice product, has backlight too which I don't think was mentioned. You can wire that to your headlight circuit or the same as the power if you don't want it switched. Installation is reasonable and varies depending on your application of course, in my case on a 1980's Club Car I had to mark and cut the opening because the one meant for it required tank removal and I didn't want to do that so I installed it where I had access. There is a chart that is slightly confusing but helps you set float. And what I did was drain gas and tweak the float setting. I didn't try super hard to get it super accurate but have it so it goes to "E" pretty close with some error on showing "E" when there was a little left, so it works and will keep the wife from getting stranded in the back yard or down the street. :-)

Awesome product easy install have to ground sending unit to the bolts on top of sending unit great value for the money and accurate seems durable and will work great

Direct fit into existing locations works, as it should only thing was the stud on the sending unit for attaching the wire was not tight enough, and it leaked, but by removing the wire and tightening the nut on the stud half a turn it stopped

I bought this to replace the old and broken fuel sending unit on my 1971 Massey Ferguson 50A. Took a little bit of fiddling but in the end it's doing the job.

Good little kit fair price

My boat has a in seat gas tank with angled sides. A vertical float set up would not work. This set up works very well and was very easy to install. All I had to do was measure my tank depth. Set the A and B lengths as per the clear directions. The is no guessing anymore on how much gas is in the tank! The gauge has a bright light and is very easy to read.

Installe sur un backhoe fonctionne a merveille