VViViD Micro Bio HEX+ Air-Tint Headlight Taillight Tint Vinyl Roll (17.9" x 60", Clear)

The media could not be loaded. First time wrapping anything automotive, and I have less than a handful of newbie DIY mistakes (lifting at corner edges due to not stretching enough).That being said, the clear Bio HEX is subtle but gorgeous. One roll allowed me to do all my rear lights - uppers, lowers, and brake light.Vinyl doesn't impact the visibility of my lights, and because of the lack of tint, I'm not running afoul of any laws.Application was surprisingly simple - repositioning, lifting, and stretching the film was easy and user-friendly. Very little heat needed to manipulate and stretch the film around curves, but you do still need a heat gun. I had no tearing or bubbles, but I did take my time (as you should) to be sure I was getting as good an application as I could for my first go.I can't yet speak for how well it comes off, but will update this once I pull off the film to redo the sections that are lifting (again, 100% user/beginner error). But, even with the lifting, the film has remained intact and nothing has been able to get under it in the couple months I've had it installed.Watching professionals/videos, reading up on the process, having the right tools, and most importantly, having a lot of patience is what's going to get you the best results if you've never worked with automotive vinyl before.Overall point: wonderful product, easy to work with, 10/10 would recommend and use again

En este tipo de paquetes considero que también debe etiquetarlos como frágil, porque el rollo se aplasta y el materia se daña.

This is not the first time I have bought this wrapping it does a good job of protecting the car

This always an absolutely great tint! First, it's quite cheap and you get a good amount for the price. It is true to its claim of "peel it off and re-stick it". I do recommend a heat gun on low or a hair dryer with heat, it does assist in applying it with no air bubbles. Doesn't obstruct headlight visibility while still looking visibly stunning. It also does have some stretch to it while heated which wrapped the corners nicely. A+ product!!

Most Vinyl wraps I use don’t mind heat of between 200 and 250 Deg. This one if you heat it to 200 it leaves the glue on the car not on the Vinyl and causes it to bubble. I had to redo one section because of this. It would be nice if it come with heating instructions. It works ok at 90 Deg