Description
- About this item
- Force Rating: The resistance of the installed anchors to extraction depends greatly on the nature of the asphalt and the gravel below it. The SP10-38 are pull-rated for 1,500 lb. (680Kg or 7KN) if installed using a 7/8” (22 mm) hole and the EPX2 grout. At ground level, the anchors can resist at least 1,000 lb. (475 Kg) of shear force. The anchors are rated for 200 in-lb rotary torque; this torque is exerted when tightening the attaching bolt.
- Large Washer: The washer prevents the anchor from dropping below the surface, and guards the thread from the grout spilling into it. The washer prevents static pull forces on the anchor when a structure is attached to the anchor. Such forces are likely if the head of the anchor is smaller than the hole in the base of the structure being attached; in the latter case, as the bolt is tightened, the anchor would be pulled up through the hole into the base.
- Installation: The installation requires drilling a 7/8” (22 mm) hole, 6” (150 mm) deep, into the asphalt and the gravel below it. The hole is filled with EPX2 grout and the anchor is dropped in. The anchor is ready for use in 15 minutes (depending on grout and ground temperatures).
- Benefits: Installed anchor is flush with ground. After use, can be left in ground without danger of pedestrian tripping.
- Applications: Mounting of Parking Barriers -Speed Bumps/Humps -Parking Blocks/Stops -Bike & Kayak Racks -Fabric-Sided Structures -Blast Deflectors (airports) -Sound Barriers -Fences -Signage -Carports -Lean-to Sheds -Shelving -Shopping cart corrals -Street Lights -Traffic Signs -Railings and Guardrails -Bus Shelters -Equipment Platforms -Static Discharge poles -Bleachers -Oil Drums tiedown -Solar Panels -Outdoor Furniture -Steps -Cable troughs
The SP10-38 is used in conjunction with our EPX2 grout to bond with existing asphalt. Constructed from zinc plated steel, the bottom of the anchor is flared and sealed to act as a wedge when pushing the anchor into the ground. A welded spiral along the length of the anchor provides for a strong bond with the grout. The top of the anchor incorporates a large washer with internal female 3/8" thread accommodating up to 2" of thread. Supplied with 1" washer and 3/8" x 1" hex-head bolt. REQUIRES 1/2 BAG OF EPX2 PER ANCHOR.
