12'' X 24''Aluminized Heat Shield Mat Thermal Barrier Adhesive Backed Heat Blanket, Fiberglass Insulation Reflective Material High Temp Protection

It helped greatly in reducing the heat generated in my 1977 Corvette.

Inexpensive way to shield heat from the exterior grill to the refrigerator on our RV. I cut this in 2 pieces and attached this to some thick plastic posterboard. When I pull the grill out, I place this behind it and in front of the little refrigerator. Works great to keep grease splatter off the fridge too.

I was rather hesitant to buy this but I figured I'd give it a shot. I used it above the heater in my SXS so the plastic didn't melt. So far so good. Easy to cut and the adhesive has not failed yet. Pretty impressive.

Worked just fine. No issues

The product itself seems to be good at heat resistance, it's not just stamped thing aluminum as the product actually has fibers. My issue with it is the adhesive is very weak, even with cleaning the surface well removing all dirt and oil, it will still very easily peel. I'd give it a 4 or maybe even a 5 if the adhesive actually stuck on well.

I purchase this Heat Shield Barrier to protect my Carbon Fiber BMW ///M Engine Cover. I cut the the Heat Shield Cover the same size as my BMW ///M Cover and the Heat Shield Cover is doing a wonderful job. I would recommend this cover to my friends and BMW Community/Club...

The price is a little high but it worked like a charm. I used this to replace factory heat shield over dry rotted loom. I replaced the loom and used this heat shield, the adhesive worked great.For better results over loom, I always wrap the heat shielded area with electrical tape first, then very tightly and neatly wrap the heat shield. After it's wrapped I use a butane torch and heat the heat shield all over, this will help the adhesive stick.

I used this for the underside of my valve covers’ cover…….. but the heat shield simply peeled away after the car warmed up. Maybe I need to clean the contact surface better? Just be warned that you might need to add your own adhesion promoters for this to actually adhere