PreGlued 1/8 RC Monster Truck Buggy Wheels and Tires 17mm Hex with Foam Inserts for Traxxas Maxx Tmaxx E-Revo 2.0 3.3 Arrma Kraton Typhon 6S HSP HPI Savage Flux Redcat Kaiju

These tires seem to be made out of very good rubber minimal ballooning they are just under 6inch tall little smaller than the tires that were on my 1/8 Kronos actually made it handle better a little bit quicker off start and up to speed quicker check the height of your original tire before purchasing also this tire in the bigger size is well over 6 in I didn't go with that because I dudnt want to go bigger than my stock tire

They appear to be of decent quality. I bought these strictly to stud for ice tires I have not tested them yet or before hand so I will update as soon as the ponds freeze up. They will be mounted on a 100% custom kraton that runs at 70mph. For those interested a bucket full of acetone for a few days to unglued, gorilla tape on inside, #8 3/8 truss head screws of the stainless steel variety 288 for all 4 tires poke through the tire about 1/8 inch. Pain in the tuchus but I think it will be worth it.

I haven't been able to use my Traxxas Sledge since purchasing these tires very much. But the little bit I did drive it these tires seem to work fine, but the compound is a little stiffer and does not seem to get as good of traction on the asphalt. Being a little shorter than the stock tires you lose some top and speed but the trade-off is it's a little snappier on the low end. And for the price they're definitely worth a try. My factory Traxxas tire had a foam disintegrate after 10 runs!!

The wheels are amazing in every way. Grippy sleek looking, the whole 9 yards. Only thing I found off-putting is they seem like the off set is off but after reading the description I realized that these are for emaxx, arrma truggies. I'm going to beat them until they are no more but by the way they feel and act that's gonna be a while.

Used on my v1 and v2 maxx, both widemaxx kits. Much much much better than the factory tires for preventing rollover during turning, but they do take in a bit of water. I recommend covering the hole in the inside of the wheel, either than that they are surprisingly grippy and much wider than factory maxx wheels and tires

The rims were so thin that the wheel nuts bottomed out on the threads before fully grabbing the rim. Not surprised they all 4 cracked and one demolished on the first run. They are made of a hard fragile plastic and it is not flexible at all.

I ordered these for my maxx was out playing with it blew a hole in the center of the tread.

Does not fit the arma Nero! Seem like foot tires and came quick!