MakerShot Magazine Speed Loaders, Designed Specifically for Each Selected Magazine

Works perfect for a magazine loader, makes loading so fast and easy. Plus a very good price.

It works perfectly once you figure out the basics. It is a trick to it, but if u can slide a round, you can figure it out. Definitely makes it easier and quicker to load magazines. I thought I was being frivolous buying it...I wasn't.

It works. Definitely easier than loading without it. If the plunger would have went just a little farther down for you to perfectly place the next round I would probably give it a 5. For the price not bad.

Perfect fit and function thank you.

Review of MakerShot Magazine Speed Loaders, Designed Specifically for Each Selected MagazineThis is a simple magazine speed loader. There’s nothing to really break or go bad unless the small plastic piece that pushes the rounds down would break. This works well with my Sig Sauer double stack for my 229 in .40 caliber. I have not tried it with my duty weapon, the Glock 22 Gen 5 .40 caliber yet. As with most magazines, it’s the last few rounds that are the hardest to load by hand. This is no exception as far as resistance is concerned. This just makes the entire loading process so much easier on your fingers. I found that it was necessary to put my magazine on a hard surface while loading the last 3 or 4 rounds, but it was easier to do the whole magazine that way too. Pressing against body armor while using this loader would likely work too. It just takes a little practice to get into the rhythm.

I bought this loader because the one I got with my pistol was a very generic fit, and was very difficult to use. The pistol is an older Sig P938 9mm single action. It looks like a shrunk down 1911, shoots reliably with no problems.The loader had some minor fitting problems. There was too much room front to back that I shimmed with a thin strip of cardboard that worked well, and the reduced movement helped loading. The width was perfect.The problems are not so much a fault in the loader design or material, but are with the Sig magazine Itself. One issue with the magazine is the tension in the magazine spring is very stiff. Also the lips of the magazine that hold the top cartridge only hold about 1/3 of the bullet case. The cartridges are easily knocked out when touched. All that said, the pistol loads and reloads 100%, so Sig designed it very well. However it is difficult to load.Once the movement in the loader was reduced it worked pretty well, considering what it had to work with. If you are not familiar with how the loader works, the loader slips over the magazine and a little plastic piece pushes the top cartridge down, making room for another cartridge into the magazine. The short magazine lips have trouble holding the new cartridge until it can be pushed further into the magazine. Fiddly, but it works.If I were to change anything in the loader design it would be to make the pusher piece thinner, and maybe move it back 1/16 of an inch. The loader is inexpensive and sturdy, and I will use it as long as I have the Sig.I thought enough of the quality and material that I ordered a magazine holder to protect my magazine. Good company, good products.

great help easy to use

Works well for my guardian 32, some people complained about how to use it, they shouldn’t be allowed to operate a pistol or load a magazine…it’s literally dummy proof.