A-Premium Set of 4PCS Mud Flaps Splash Guards Mudguards Mudflaps with Hardware Kits Accessory Compatible with Toyota Sienna, 2011-2017, Van, (Not fit SE), Black Color, Front LH RH and Rear LH RH

Others have placed negative reviews on lack of hardware. Yes there are extra holes in the mud guard, but my car didn’t have screws or holes where the mud guards mounted. The front driver side guard need a little trim with a utility knife to sit flush, passenger side fit flush. The driver side rear needed a little work because there was a push lock already in the spot where the lower( underneath) screw would’ve gone. I just pulled the push lock out and drilled a hole in the center to insert the provided screw. A little work, but for a $25.00 set of mud guards it was worth the extra work.

They looked just like OEM - and so simple to put on. They seem to be of good quality too!

I had to trim a small piece from the front, left splash guard but it fit fine afterward. I have to admit I like the way they look.

Fits Toyota Sienna 2017. Each splash guards have 3 holes. Comes with 8 screws and 4 mounting clips. Using any brand name Right Angle Drill, Remove 2 existing screws and mount the front guards. Drill 2 holes to mount Rear guards. Finally drill holes for the guards bottom side to keep them in place. Splash guards are flexible and easy to drill.

Easy to install and they look nice. I did use a razor blade cut off some of the mudflap on the driver left. Overall good product.

Was kind of hesitant with the reviews of the missing hardware. However for the price couldn't resist. Worked perfectly for my 2014 Toyota Sienna LE. Hardware was on point since both sides for the front already had fender screws already in place just needed to use 1 screw each on the underside just used a small powered screwdriver. The rear I used the 2 screws each side in the top two screw holes on the flaps although there are 3 holes; I had to drill with 1/8 bit into non metal wheel well after marking the holes with a black sharpie-since the drilled holes were marked close to the edge, I install the tap on either side of the lip, then lined the flaps and screwed the under side and that was it. All-in-all took 30 minutes because I was going back and forth with NCAA game.

At 30 below Fahrenheit drove thru deep snow and broke the right side flaps off the wheel well

Rain or shine protect your paint and body with a set of quality mud guards. Fit and finish were on point and easy to install. Your vehicle deserves it.