15 Pack 1.5 Inch Desk Cable Hole Cover Grommet - Plastic Wire Cord, Black

I bought these grommets for a custom desk I built and these grommets work great for allowing the wiring to pass thru. They are also a great price for a 10-pack. So if you are looking for something like this I recommend these. They are great for cable management, and are easy to install. Perfect size for what i was looking for. The black color worked great for me. You can use them with the cap, or without like I do because I had a lot of wires to pass thru. I give these 5 stars.

These things work great IF you buy the right hole saw for them.DO NOT use a 2" hole saw or the hole will be too big and sloppy.When you order these, also order thishttps://www.amazon.com/gp/product/B07R8YFZWF/ref=ppx_yo_dt_b_asin_title_o04_s00?ie=UTF8&psc=1This is a 1-31/32" hole saw (50mm)Make sure to use the drop down menu for size and choose 1-31/32" (50mm)This will give you the perfect size hole for a nice interference fit.You can smack them in with the heel of your hand and they fit perfect !I used a caliper to measure these grommets and then converted the thousands to fraction and millimeter.I then ordered the above hole saw and the fit was perfect in a 1" thick plywood workbench.If you try to use a 2" hole saw, you wont be happy with the results.These are a great value for the money IF you have the right hole saw.The seller should not be claiming that they are for a 2" hole because they are not.

My wife and I made an office work area out of IKEA cabinets and countertops. I purchased the 2 pack to run the monitor cables through one grommet and the mouse and keyboard chords through the other to ease congestion. They are smaller than I had envisioned which is the only reason I put a 4 rating. Do not make the same mistake I did and use a 2 1/8" hole bit. I thought it was a 2". NOTHING A LITTLE CONSTRUCTION ADHESIVE CAN'T FIX! AMIRIGHT!!!! :)

Great product, nice design and color for a modern finish

Plugs were as advertised and would purchase again.

Bought these to fish power cord and cables to TV I hung on the wall in master bedroom. Put one behind the TV and one just above the baseboard near power outlet. Smaller and less expensive than the outlet size boxes sold for this purpose. Very happy with result. One reviewer complained about hole size and fit. They work perfectly in drywall using a 2” hole saw. Neither too big nor too small. Since they are in drywall instead of wood, I used a dollop of acrylic caulk to “glue” them in place. Once this dries they are flat, tight, and in place for good. Great to have 8 spares from this purchase.

I purchased this for some new shelves we had installed. They work great and were easy to install. This allows me to place my speaker and some items on the shelve even thought the outlet was below. It gives a clean look

Work well but… you’re going to want to put a screw in this. If use a 2 inch also it will sit loosely however it’s easy enough to throw a 16th inch hole in and screw it in.I used this for running holes through cabinets. They will never be seen however I like to have a good finish to my products. Therefore putting in a cheap grommet so no exposed particle board from the melamine will show for customers who like to inspect installations. You will never receive a complaint from a customer if you utilize these in your work. I plan to continue to use them because of their low cost. I find a better price on a larger bulk item I will switch over to those. But this will work for now.