AET DLBB1G35 35 mm Single 1-Gang Dry Lining Pattress Back Box - Color may vary

A good quality item fits well and did the job

Well made ,but a different type I am use , side by side movement of the yellow clamping lugs is very tight and can be problematic once fitted, so before fitting I eased of the retaining lugs with a screwdriver fitted on the base of the back box, now slides more easily.

Was expected and did the job.

I needed two of these so I could route AV cables in the wall cavity behind my wall mounted TV. After tracing around the rear of the boxes, I was able to cut out the plasterboard with a Stanley knife, the box was then pushed into the hole and was a nice snug fit. After pulling the tabs forward to clamp it against the plasterboard (which were red not blue by the way) I was able to screw the wall plate in to place, the screws tightened up all the way and gave a nice tight fit.If you are using the back to take a power socket you can feed the mains cable through one of the slots located at the top or bottom of the box. As I was feeding several AV cables I used my Stanley knife to cut out the circular hole at the back. The hole was big enough to feed 3 HDMI cables, TV power cable and an Ethernet cable.Overall this is a good quality item and they did the job perfectly.

What was shipped is not what was in the photos. Clips already in place, and I cannot unclip them.

Not much to say but sturdy, not like some flimsy ones you can get and easy to install. Great price too.

Great for moving a light switch in a plasterboard wall. The lining is just visible if you look hard when the switch is fitted, but not obtrusive.

I needed this design as the flappy wing box style wouldn't fit the hole. This one was perfect, and, honestly, a better design.