Tool Daily Quick Connect Turbo Nozzle Universal for Cold Water Pressure Washers, 2500 PSI

works well

Wish I would have known about rotary nozzles earlier. This does a much better job of removing old paint than regular nozzles. Makes it seem like I'm using a much higher pressure than I am. Using it on a 15 y/o 2300 psi pressure washer. Has made prepping my siding for a paint job much quicker and easier.Yes, you need to use teflon tape on the quick disconnect like some people have complained, but they provide a roll, so I don't understand the whining about this.

has been quite impressive. What this device really does is take the high pressure nozzle - which makes a very concentrated, narrow stream, and rotates it extremely rapidly, applying that high pressure stream to a much wider area, enabling you to get really deep grunge out of surfaces quickly. You must remember, though, that this is the highest pressure stream that your pressure washer can provide, so it isn't going to be suitable for more fragile or delicate surfaces. It could destroy them. It is great fro removing dried paint from concrete. It will also remove loose paint instantly from any surface - but bear the caveat above inn mind: Test the material before you go all in... You could save yourself some grief. I got a 27' X 50' driveway looking like brand new in less than an hour, in Florida. There's a lot of lichens and other tiny growths that like the heat and humidity there, and will make concrete look nasty in just a year or two. With this nozzle, that stuff was gone, just about as quickly as I could move the wand back and forth. I think it's excellent for what it is designed to be, but be aware that it can be too powerful for some applications.

I was unsure how much I would like this in addition to my multiple individual nozzles, and after usage, I like it quite a lot. The spray exits in a rotating fashion, so you get the benefit of very high pressure narrow spray, but the rotating pattern prevents damage to whatever you are spraying and allows greater coverage area with each pass.. so definitely 5 stars for the price vs benefit. I am not sure if this item is any better than others that are similar, but I like it.UPDATE: have used the item for over 10 hours of solid pressure washer use, still holding up fine, a great addition.

I have 2000 PSI pressure washer and despite the negative reviews I went ahead and ordered one of these! This thing works great! The only problem I had was a leak at the 1/4" NTP thread where the QC fitting screws into the nozzle. I simply took it apart and put more of my own (thicker) teflon tape on it and screwed it back together a little tighter this time. No more leaks! The manufacturer should tap that hole a little shallower! Use an accurate american NTP plug gage! Overall, I'm very satisfied!

Too much overspray on my three inch algae covered fence pickets.

My 2500 psi washer was not getting the job done. I was considering renting a p/w with a higher psi for my project. I decided to give this a try first and the results were amazing. Highly recommend if you have a tuff job.

Nozzle orifice is perfectly sized to my Husky 1750 psi, 1.6 gpm pressure washer. I did have difficulty getting the quick connect fitting to seal, once that was sorted... the nozzle works great! To get a good seal I used about 12 wraps of the supplied Teflon tape, and tightened the fitting until it bottomed out.