PowMr 10000W Solar Inverter 48V to 120/240V Split-Phase Output, Split-Phase Hybrid Inverter 10000W Built-in 200A MPPT Controller, Support 6-Unit Parallel and Can Batteryless Run

Works well. I have it connected to 6KW of solar power and 30 KW of LiFePO4 battery power. It has supplied full power to our house with no issues. It replaced a pair of Growatt 3K all in one inverters that were on rare occasion a bit too small for our power demand. I use a variable speed inverter heat pump HVAC, a heat pump water heater, a microwave, and a heat pump dryer, (gas stove). Through two Hurricane power outages, the lights stayed on, even powered a fridge next door.

Just received this and got it installed the very same day. So far it is everything that it was advertised to be but, I will have to give it a couple of months to see what the effect is. Very easy to install and the response to my questions came very quickly. I am thinking I might just order a second unit so I can power everything on the property.

I got two of these; one worked, and the other didn't. It misread voltages and had alarms that beeped constantly. Customer service was the worst I have ever had (there was no US number to call, and communication was only through email). Initially, the company seemed helpful, but in reality, they delayed and delayed until I gave up. There is no customer empathy, and I will never buy from them again. [update] The 2nd one just died after barely a year.

Any trick in getting data logger installed? Ordered logger from PowerMr web page for 10k inverter. One green light on logger comes on nothing else. Contacted PowerMr support and they want a picture of it not working.

Lo compré para mi país Cuba ya q ahora enfrenta los apagones si estás pensando poner paneles este es el mejor cómpralo no te errepentiras

I hope I don't jinx it by putting in a good review, but it has been great so far. Running for about 5 months now. It even has enough oomph to run my 6hp air compressor. Update: Having had it up and running for about 7 to 8 months now, I was really satisfied with its performance. Especially on the inverter side. There is always plenty of power coming from the unit. The problem I'm having is on the charging end. For unknown reasons the unit has stopped charging properly. It used to keep the batteries full at all times going into a sort of float charging mode. Now it only charges sporadically with no rhyme or reason. I have checked solar panel output and it is getting plenty of power from the panels. Even when I hook a generator up to it. It still does the same thing, so it's not a power in issue. It often lets the batteries go down to zero before it starts charging again. Sometimes I can get it to start charging if I turn it off then turn it back on. However, that does not always work and obviously it is a pain in the neck if I'm trying to have an automated system. Sometimes the unit will make a squealing noise when it goes into the charging mode as if one of the fans is binding up, but that is clearly not the cases. I can hear the fans roaring. I have not changed any of the settings since I had installed it so nothing has changed. I have gone back and rechecked the settings to make sure they were all correct. I later tried changing the settings to see if maybe a different charge rate would help. No luck. The unit worked great for the first 6 or 7 months and is now worthless to me.

Es muy buenos

Lists grid tie as an option, doesnt tell you its not certified for your country, it wont even try. Liars! Tech support told me to buy a diff model after lots more lies. Uses 75 watts in standby, 270ish in any other mode, wont stay turned off if solar makes 10 watts it turns the whole unit on. Uses a ton of energy in idle. Not impressed. Also does not allow for 6ga wire for input or output of ac like claimed. I tried coarse and fine stranded. No way. Lots of features that do work. Seems to charge well but doesnt make full use of solar, my other brands make 20% more. Inverter seems reliable and powerful. Started a 5hp compressor and ran for several mins while i had 400 watt lights and several hundred watts of computers and tvs on. Build has 0/1 ga wire off 12 100ah gels.