220V 850W LED Microcomputer Electric Hot Plate Preheat Soldering Preheating Station Welder Hot Plate Rework Heater Lab 200X200mm Plate

El producto llegó en buen estado y la calidad es buena. Llevo tiempo usando este producto y ha funcionado correctamente, cumple con lo que promete.

This has worked amazingly easy for me. I've had no previous experience with SMD, and I managed to make several boards over multiple days without problems. Large platform, smooth and even temp. The only issue I ran into was the display reported a temp 12 degrees higher than actual, but that was fairly easy to apply a correction for - In my case I pressed and held the set button for 10 secs until the display changed. Short press the select multiple times until you see SC on the display, use the arrows to adjust the correction up or down (in my case down 12), then press the select button again. It'll show LCK after that. I just waiting then until it timed out. After that it was showing the correct temperature. It has a REX-C100 controller for the temp.

Good quality. Solid built. Very helpful in my work.

Works well, just try not to get flux on the surface. It heats up fairly quick, and stays warm for quite a while. The base its sturdy, and it weighs enough I'm not worried it'll get knocked off a table and fall on someone. For one-sided PCBs, I can make a batch of them in just minutes once it's up to temperature. I haven't heated it past 260C, but I'm sure it could exceed that without issue. For the money, great value, and it's convenient to solder several boards at once.

Hasta el momento todo bien, se siente de una calidad acordé al precio.