Brushless Rc Motor, Surpass Hobby 3680 1800KV Brushless Motor with Cooling Set Design for RC Boat (1800kv)

great motor can not wait to get it on the water in my 3d printed boat.

put this in a fiber glass 27" mono hull. On 4s 50c packs with 150a esc I hit 60mph and do it within 1-1.5 seconds. Thing is an absolute rocket. motor doesnt even break a sweat. well under 100f. Comes with a data sheet showing all the specs of all their motors which is quite handy. Finish is nice, end play is minimal, motor is rebuildable. Only thing I did was remove the 4mm bullet connectors and replaced them with 8mm big boys.

Thing never runs out of power. Both my 36 and 42 in boats ate it up...

Perfect for my 3d printed rc boat. Super fast on 4s lipo.

These engines are extremely powerful And work great for my high-speed planes

No bolt pattern given only for boats 👎

Very well made and performed as stated.

Awesome motor it's going on a vintage hydroplane Miss Budweiser

Quality motor, smooth large bearings, pure power on the test bench. Can't wait to install in new jet boat.

After doing a lot of math to achieve scale speed, I then upped the wattage 3x. I can limit to speed of the boat, by adjusting back the end stops on the receiver. Goes like stink at 60% and does not even get warm, even without the water cooling.

Fonctionnel