This product is a high sensitivity automatic light detector switch, It has wide detection range made up of up and down, left and right service field; It utilizes human motion infrared rays as control signal sources, when one enters the detection field, it will start the controlled load at once; It can identify day and night automatically; It is easy to install and its usage is wide; It has the function of power indication and detection indicationSpecification:Power Source: 220-240V/ACDetection Range: 180Detection Distance: 12m maxWeather-proof to IP65Wall Mount or Ceiling MountPower Frequency: 50HzAmbient Light: 3-2000LUX (adjustable)Time-Delay: min: 10sec +/- 3sec - Max: 7min +/- 2minRated Load: 1200W (incandescent lamp) 300W (energy-saving lamp)Power Consumption: 0.45W (work) -0.1W (static)Detection Moving Speed: 0.6~1.5m/sWorking Temperature: -20~+40CInstallation Height: 1.8m~2.5mRetail Pack Includes:1 x Infrared Motion Sensor in Black1 x User Manual in English1 x Set of plugs and screws ( 2 pcs each)
I**R
Works very well so far.
Product works very well and connecting was no problem the only problem i found was the screw that holds the unit to the base was so very short that although it was ok to use When the unit was on the workbench it was almost impossible to start when the unit was mounted on the wall. I found a slightly longer one in my box of screws and the problem was sorted.
P**L
Poor design and quality, so very difficult to install
Installation was difficult, because:- Cable grommets are too small. The only way to get the cables in was to not use grommets, which meant I had to seal the holes with sealant afterwards.- Not enough space in the back for cables.- Connector strip doesn't have a spare way for an earth connection. The PIR itself doesn't require an earth, but need to pass through an earth for a metal light fitting.- Two of the metal connectors split when terminal screws were tightened (see picture)Once finally installed, the PIR appears to be working well.
F**K
Works well
This was installed to operate two lights at the front door, so that when people approached the house the lights operated. With the wiring of two lights to feed it was a little tight on space. There was no provision for the earth connection so i mounted the device on a wooden block to give space to connect the earth wires together. This being summer the lights have not been tested as it is still light until almost 10 pm. The test provision worked very well and when the lights are required it will be easy to adjust.
H**E
Good but Flimsy
Plus points: Good detection. Clear controls for duration and daylight control. Good articulation.Bad points: Flimsy compared to previous PIR. Sticks out far from wall. No earth connection in internal block
M**H
Good product and good value for money
Second one I bought from these guys, really good product and good value for money… slightly tricky to setup but that’s fine once you get the hang of it.
B**N
A good product
Used to light up area between house and garage. The LED motion detector is very sensitive and does the job.
N**.
It works
All good so far. It works and has a good range.
N**.
Have patience!
Parcel arrived ahead of scheduled delivery. Item was well packaged.Sensor functions as expected.Tight fit for the three wires in the housing, so had to shorten the wires and even then it was a fiddle to close up the housing.
Trustpilot
1 day ago
1 week ago