Repalcement Circuit Board PCB Ribbon for PS2 Controller Conductive Film Keypad SA1Q43-A (2 Pieces)

pressure sensitive button presses register would give 5 stars but the following will expand upon why i did not give it 5 stars. some trimming around the L2 and R2 buttons is needed. Be very careful not to severe traces. also needed to trim around where ribbon connects to the controller pcb for more secure fit. These are 18pin ribbons, while an OEM controller takes a19pin ribbon. looking at the controller with the stick facing AWAY from you insert the ribbon cable leaving the far left side unoccupied then close the clamp and you're good. all buttons will work.

Junk!!!!!!!! Had to trim on them for hours and tape them in place to get all the buttons working.. Had trouble getting the select button to line up.. Used double-sided tape and Kapton tape to make them work. If you have patience and hours to burn, go ahead.