HHIP3900-2112 58 Piece Clamping Kit (7/16 Inch T-Slot) Stud Size 3/8-16

Cumple con mis expectativas

good

Works well and seems to do the job. Good combinations of sizes too. Some of the nuts and rods are a bit scratchy feeling when threading them together with your fingers, but will likely free up after a few uses. I will buy them again if I ever need more.

The clamp set I received was very well made had none of the milling flaws other reviewers experienced: the threads were clean and the steps on all the blocks were sharp and fitted perfectly. My Smithy CB1220 XL has 7/16" slots on the table, and I've had trouble finding that size; 1/2" and 5/8" seem to be more common. Smithy's set has fewer pieces than this one, and runs about $100 with shipping. As usual, Amazon saved me more than half. The set arrived in two days. The plastic case is very sturdy, and suffered no damage. All pieces were well-oiled and clean.

This set is extremely good for clamping odd-shaped pieces. I think I paid about $65. I did have to take the bottom out to retrieve a short threaded rod that I dropped into a hole and the rod went down inside. I have since built a milling table with drawers, and I have transferred the clamping kit pieces to the top drawer. Do at your own risk, but I also bought a 4 inch quick-slide vise, and angle vise, and a 3 inch machinist vise to go along with this kit so I can now clamp just about anything up to 4 inches wide. I use this on a HF mini mill.