Hobby Fans Mini Gyro Module RC Car Gyro Stabilizer Automatic Stability Control Gyro Sensitivity Adjustable for RC Crawlers Cars and Boats

I put this gyro on a kraken vesla.5 buggy. It is a 35 lb land middle rc car. It is a 2wd buggy that runs 8s power. The car would always spin out due to brutal power of the motor. The gyro fixed that right away. Easy to adjust and seems to hold adjustment really well. Comes with mini screwdriver to adjust and mounting tape too. I don't think it would work on a competitive drift car, but for off road and su h it is great. I will try it on a drift car and report back. It is a good gyro for the money and works great. Keep in mind the adjustment is backwards from typical adjustment su adding more response to gyro is turning adjustment to left. Once you know that your good. Enjoy.

Great gyro

There is no feedback on the adjustment screw so unless you mark the original position it's difficult to make fine adjustments. The plastic of the adjustment screw is so soft it began to deform and shortly after adjustments stopped working entirely.

Sigh… Im just getting into mini drifting and understanding gyros. You get what you pay for. I installed this and after researching, I realized in order to get a good gain with no twitch, I would have to turn it down so low that it doesn’t even do what it supposed to. The twitching gets so bad, the wheels rapidly change direction when going straight causing crashes and even burned out my servo. I might test it in my 1/10 buggy and see how that works, but if it does the same I will return it. Better to spend a few extra bucks and get a good drifting gyro. I dont recommend this one for drifting.

The media could not be loaded. This small gyro is a nice module that can help to stabilize an RC car or robot that it is attached to. When added to the servo path it doesn’t introduce jitter and doesn’t seem to add long term drift. Made for use on RC cars, it will also work on small robots to help to keep them moving in the direction desired. Want your robot to run in a straight line, this will help you do it. The gyro uses standard 4-6V servo PWM signals at the input and the output. This makes it easy to use on both cars and robots. The input signal is the reference value usually from the steering channel of the receiver. The output signal is equal to the reference (i.e., receiver steering channel) plus or minus the deviation value caused by the gyro being turned, which is attached to the car. The response can be either to turn into or turn away from the direction the gyro is turned. The module has a button that can be pushed to change direction. There is also a “gain” pot that can be adjusted to increase or decrease response to a gyro movement. Basic instructions are included.This is a simple to use and useful module for hobby RC car users and small robot builders.

It works, but it was all but impossible to reliably stick a tiny Phillips head screwdriver in the hole and know whether I'm turning it or not and adjusting upwards or down the effect of the gyro on the steering. I would much recommend paying up a bit and getting a Transmitter and receiver with built in gyro, which can be controlled from the transmitter.So ease abuse was not that good and quality was fair only due to minuscule adjustment arrangement. Value for money is probably pretty good and appearance was fine.

This gyro works well on my buggy to keep it straight. But it did not work so well on my drift car. The response is not fast enough.