

🌡️ Stay cool, drive smart — never miss a temp spike!
The WATERWICH 2-inch (52mm) Water Temperature Gauge offers precise coolant temperature readings from 104℉ to 300℉, powered by DC12V. Featuring a bright red backlight for night visibility and an overheat warning lamp above 212℉, it’s designed for easy installation with included sensor and wiring. Compatible with a wide range of vehicles, this gauge ensures real-time engine monitoring to protect your ride.







| ASIN | B0CY547LGY |
| Best Sellers Rank | #698,935 in Automotive ( See Top 100 in Automotive ) #25 in Diagnostic & Test Thermometers #136 in Automotive Water Temperature Gauges |
| Date First Available | March 15, 2024 |
| Item Weight | 4.2 ounces |
| Manufacturer | WATERWICH |
| Product Dimensions | 4.92 x 3.15 x 3.35 inches |
J**E
Works as mentioned
Easy install works great simple look
F**A
El medidor salió muy bueno, ya lo instale, pero no tomé foto.
M**H
Works till you hit a hard bump.
It's pretty accurate until you hit bumpy roads then it jumps all over the place and stays at max temperature until the vehicle is shut off and restarted. Then the same thing happens again. It has to be the actual gauge because resistance sensors rarely fail.
M**K
Good Quality
Very nice and easy to install
R**E
good deal
good deal
J**Y
These work prferctly but the mounting trim bezel rusts.
I added one to each cylinder head of my 150 hp Johnson outboard so that I could monitor the water temp on each head individually. These work great for that purpose & have been installed several years. Unfortunately; the mounting trim bezels have corroded & need replacement. My other 2" dash guages (fuel, trim etc) have rubber or aluminum bezels & don't rust.
A**T
Defective upon arrival
The sensor on this items was defect and would not read anything other than 104. I tried calling the product support number listed and it was not the correct number, it went to someone’s personal phone who reported Amazon would not fix the phone number. Since this is a two piece install and required soldering for my application I only wanted the sensor replaced but that was not an option.
M**E
Didn't work for long at all
Lit up for about 20 seconds and that was it, looked good for 20 seconds
Trustpilot
2 weeks ago
3 days ago